Yep. That's what they said when I first spoke with them.
After talking with Lippert and receiving their build/assy pdfs, I have confirmed Heartland installed the forward-most slide roller on the main slide way too far in from the wall edge. That has caused the floor of the slide to sag...
That's the plan, thanks. I've decided to mount the inverter in a far less ideal location, since it would exceed (double) Go Power's recommended distance from the batteries. Rather than trying to figure out the proper wire gauge for that length and fuse block requirements. I already ordered...
I did, thank you for that. I'm just a bit annoyed with Go Power overall, in regard to the many different versions of the exact same "options" they have. The printed manual conflicts within itself, the online info conflicts within itself, and they conflict with each other. This leaves me...
Yes, I have the Onan 5500.
- - - Updated - - -
None of those items would be used while boondocking, except possibly the microwave. What would happen if the microwave would be used?
I also don't have any usable location within Go Power's preferred 10' between Inverter and batteries. My...
Thanks for your reply danemayor.
Yes, I will be removing the OEM converter.
At this point I am planning to skip the main panel and have the inverter go to the sub-panel, which is Go Power's option 2. I wasn't aware of the potential effect on the PCS. Will wiring the inverter to sub-panel...
I just mounted a Go Power IC 2000 inverter near my transfer switch in the basement area. Go Power paper manual wiring diagram and also online diagrams and verbiage seem to conflict a lot. I want to have the setup - shore power-transfer switch-main panel-inverter-sub panel. What concerns me...
So it turns out, the factory grounded the leveling pump to the painted sheet metal wall in the compartment. Once I replaced it with a direct ground to the battery, the jacks function as they should. According to Lippert, wanting to dump the rig on its side in auto-level could also be caused by...
Good suggestions danemayor!
Everything... wires, connections, no fluid leaks... look fine. However, I verified today that the front landing jacks have the same problem when controlling them from the inside control panel. If I raise or lower the landing jacks using the exterior front control...
Hello,
Brand new to Heartland but Rving for 4 years. We just picked up our Cyclone 4007 with Lippert hydraulic auto leveling system and right from the start had auto level issues. It wanted to dump our rig on the passenger side! Tires were 6" off the ground before I got it to stop. Took it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.