Recent content by benmack1

Update: Did nothing to fix it, system is working fine now. THe only thing I did was take a trip with it. Got home figured nothing to lose by trying the autolevel and it worked like it should. We'll see how it goes in the future. I do like to manual level actually as I think it's easier...

I had the same problem a few weeks back as the OP. Couldn't get it to autolevel to save my life. Hooked up, moved it, unhooked, tried over and over. Called LCI and they gave me a case number and assured me they would work with me. I then took a trip with it (about 250 miles each way). I...

I called Lippert this morning. They didn't have any immediate suggestions beyond it sounded like the brain may be dead. They gave me a case number and want me to call back when I am at the trailer (I work during normal hours so it will be a bit before I can get back to them). However, they...

I saw your other thread too. I can't be so lucky that mine will magically resolve I doubt. I read somewhere in my incessant googling about doing an autoretract or full retract whatever you call it when you basically go from leveled up with all 6 posts down to all up. WHat i read was this will...

Thanks for the replies. I am leery it will fix itself but we'll see. I am operable as it seems to be able to be leveled manually OK (jacks work as they should manually). I have a 4 ft carpenters level to get it close. Not exactly what I paid for but we can go about our business. I am 2...

Trailer is 2016 BC 4010RD. The LCI level-up is failing to auto level. Jacks all work manually fine. I had it parked for ~ 3 weeks on the jacks. I retracted fine, hooked to the truck and pulled out of the storage shed up to the driveway to load up. This setting is rear lower than the front...

Camp Hatteras, Rodanthe North Carolina, outer banks August 2-6, 2015. Good family times. Had the Pamlico sound out the back of the fifth wheel, and Atlantic across the street. The outer banks are only a few hundred yards wide at this point.

Thanks, that's a great point. I wasn't thinking when I posted about the use of low. I use the high setting, I actually like the white noise so no problem for me. Will running on Hi continuously be any kind of a problem in anyone's opinion?

Thanks. I saw the other thread, I'll continue over there. I think these two threads are spot on with my 'issue'. There are many others out there calling this stuff short cycling but that is different (actually opposite I believe where the compressor is cycling, we're dealing with fan cycles)...

If I may ask, how has the t-stat replacement turned out and have you needed the circuit board replacement? I am having a similar issue with both my units in a brand new BC 4010 RD

My new 4010 RD BC is doing this same thing. First the front did it now the main AC is doing this. The fan will shut off, but I can clearly hear the compressor continuing to run. The fan then starts up again after about 5 seconds and they both run, then it repeats this cycle after a few...

I just got a new BC 4010RD and received my registration and plate from the NC DMV. I was shocked to see an inspection due date on the registration just like I have for my cars. I have other utility trailers up to 7K GVWR and none of those have any inspection requirement. Are any others from...

I was in the exact same situation looking at the Montana 3791RD (just has the residential fridge rather than propane/dual in the 3790RD). We actually were at the dealer to pull the trigger on the Montana and the BC 4010RD had just arrived and wasn't even open yet for viewing. Obviously I liked...

I need to build a shed to keep my Big Country 4010 RD....well kinda a super shed i guess. I am wanting to build a 24'X50'X14' pole barn. I am looking for anyone with experience on these especially recommendations for builders in North Carolina or south central Virginia. I am located between...

I am picking up a 2016 BC 4010 RD in the morning (July 2, 2015). I have looked at fifth wheels for about 18 months now and never had the guts to pull the trigger. We just couldn't find exactly what we wanted, this or that wasn't right. I also have had a challenge with my truck (2014 Ram 3500...