Hi there - how did you resolve the issue with the step up to desk and seating? We have a 2015 Big Horn FL and I've considered doing the same mod - the raise in floor is an issue...
I need to order the following for our Big Horn - Would all of these be ordered from the factory?
Electric Awning - the black outside section of the arm is bent - need to replace
Wheel fender for the kitchen slide out
I thought the Universal Docking Center was for charging my cell phone and ipod - man I am so disappointed to find out how wrong I was :rolleyes:. You all can stop panicking now - I found the cable hookup! YAYYYYY!! I love this site - never fails that someone knows how to direct us to a...
will check that out this afternoon...thanks for all the replies!! I was so focused on the four satellite hookups that I didn't even think to look for a separate cable connection! :confused:
Hi all - We just took delivery yesterday afternoon. Antenna works fine. On the outside of the coach there are 4 inputs for cable/satellite all of which are labeled satellite. Inside, in the Livingroom there is a double outlet - one labeled antenna and the other is labeled Satellite. Left the...
Thanks to all for the info! Checked against the list in the attachment and our unit wasn't one of the recalled units! Excited to be moving from the Cyclone to the Big Horn! :cool:
We have completed the paperwork on this unit at LaMesa RV in Sanford, FL and are awaiting delivery. While on the forum I found a thread about the recall on this model. I would like to know if this particular unit is affected. I emailed the dealer the recall info from DOT site and asked the...
2010 Cyclone 3950 has two cracked wheels: Driver side back and Passenger side front. The are cracked in the middle of the "spokes" about 1/2 way b'twn tire and wheel center. What would cause this and how should we proceed with replacement. We replaced E rated tires with F rated two years ago...
2010 Cyclone 3950: Living Room slide has started stalling during the process of letting out or in. If I stop and wait a few seconds, it will start again. I read through some of the postings within the community and suspect that fuses may be the culprit. I pulled the cover of the fuse box...
We need to replace the Lippert Brake magnets on our Cyclone 3950...can't seem to find the Lippert replacement part. Have found Dexter BP01-180 and BP01-225...not sure which one to use. Is one better than the other?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.