I installed blue rope lights with the same type of plastic cable clamps using the factory coroplast self tapping screws as you did. Its been going on 4yrs now and they still work and are in position.
If i were u i would stick with the coleman then. Ive had my brisk 2 replaced three times now, hopefully they’ve finally fixed the underlying cause but i dont think if i were in you’re position I’d take a chance.
Lippert gave me the part #236575 300:1 ratio motors. I purchased two new ones on Ebay and will then keep the one good one i have left over for a spare. I attached a photo of the old ones in case anyone else has the same ones.
Lippert might be my best bet then. I just want to make sure i get the correct one. If a replacement can be had for $100 or under i will likely replace both as i dont really want to run into this problem with the opposite side, that’s usually my luck. I can clearly see that the bad motor is...
Hello everyone, got the Sundance out of storage yesterday. Everything worked as it should except for the bedroom slide. One side wouldn’t come out of the wardrobe slide. After troubleshooting I determined the motor on the right side was shot. I removed motor and it was all corroded and rusty. My...
Ahh yes, i was speaking of 14...
414 from watkins glenn goes through Hector and Ovid on the other side of the lake. I have been that way numerous times to Waterloo. You shouldnt have any problems, tightest spot will probably be turing off main street in Watkins glenn.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.