Recent content by Reckoning_Man

Here is a drawing concept, Red is the Hole in the Floor, Black Is hole under Furnace.

Let me reword then ☺ On the bottom of the furnace, the outlet rectangle, does not seem to lineup with the hole in the floor. Is it supposed too? Or did the factory cut it too far to the left?

Furnace Outlet does not line up with floor inlet Ducking. I have a Suburban SF-35 Furnace, the outlet port on the Furnace is positioned in the middle while the floor inlet is positioned to one side. Resulting in only half of the hole open. Is this a factor defect or should I notch the floor so...