Hi everyone,
Been great on this forum, and great news is we are trading our 19 foot edge for a used 30 foot trailer. We originally bought our trailer for travel, but vehicle and work schedules aren't co-operating with that idea. We went seasonal this year and we discovered that the edge just...
I hope so too - they should take care of that bubble on the back - if it didn't adhere properly I would hope they would come good for it. We pay good money for our rigs and whether a Big horn or the smallest of trailers. I would hope for the best level of service that I have heard of here in the...
That is a good analogy, I was going to say some similar. The example I was going to use is when you buy a newly built house, and the AC unit goes south - who gets can solve the problem the builder or the Refrigeration company.
Sorry your have had such bad luck with yours. I have a 2009 model M18 and have only had a few minor issues. We had water inside the RV once but the rain was really hard from a weird angle (one of those sideways winds). It hasn't happened since. I do have similar issues as you mentioned with the...
Thanks for the replies. They did here it running. Not sure if steady or intermittent. Hopefully the seals are as said. I'll have to put some water through it in a couple weeks when I get out again to know for sure
Hi everyone,
So we loaned our trailer to father and mother-in-law. I walked him thru the trailer and all that had to be done - he took notes. Anyway it was forgotten that the pump should NOT be turned on with water hooked up. So the pump ran dry for at least 12 maybe 24 hours.
Are the seals...
I just use a good quality wax spring and fall and use 303 aerospace protectant on the roof and seals. I have never heard of a cover other than for winter storage.
It may have been that the voltage level was not appropriate for the fridge. It has a voltage monitor built in and if too low will flip over. You wouldn't notice it because at 95 volts many things will still work but the fridge wouldn't like that voltage and switch over to a more suitable source.
are you talking about the paneling itself separating or the finish on the paneling? Could you post some pictures. The only thing i have noticed is my bathroom by the sink the wall has slightly shifted out and the paneling finish separated a bit in one spot. I an not that concerned about min its...
We have the M18 as well. You can find the bypass Valves in the front storage area there is a panel that covers the back of the water heater with 4 screws. You have to turn 3 valve to winterize. 1 that enters the HW tank. 1 that leaves the HW tank and one in the middle between them.
Thanks for the feedback! It looks like a 3 year warranty on this so I will call my dealer tomorrow about having them check it out or get me a replacement part that I can swap.
Hi Everyone,
Having one of our first issues after a year with our M18. Our toilet is slowly leaking the rinse/flush water into the bowl and it is filling the bowl within an hour or two. We have a regulator for pressure and the system pressure seems normal. Any idea if this is a DIY fixor a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.