Ordered 5 Sailuns 2 days ago with Simple Tire. Just received them today with date codes just a few months old. Not bad as nobody in town carried them in stock.
Sent from my iPhone using Tapatalk Pro
Got mine from Heartland. Not too terrible. Just add up all lengths and you will cut to length when you receive it.
Sent from my iPhone using Tapatalk Pro
What Jim just said. Great people to talk with. They will even preprogram the components when you buy from them. I am very happy with my Victron setup
Sent from my iPhone using Tapatalk Pro
Our cyclone fireplace needed checking. I found the fascia around the sides and top slide up with a few bumps from your hand. Once the fascia is off you will see 4 screws to pull it out.
Hope this helps
Sent from my iPhone using Tapatalk Pro
2016 Ford F-350 with Carli 2.5” leveling kit. Half pack kit for the rear springs so the main overload is not there just a lot of tapered smaller thinner springs. King pin top with reservoir shocks. Cyclone 3513 with about 3k pin weight and I have torque airbags manually filled to 50 when...
Pullrite makes a 2k/20k. Used it for 8 years before selling that trailer and moving to a fifth wheel. The hitch is bullett proof and can be found from time to time used for half the cost of a Hensley.
Been here before. Played that game and won!!
Good luck
Sent from my iPhone using Tapatalk Pro
Just throwing this out there, but even on 30 amps you should be ok with the heaters. Assuming most other things are off.
Have you tried both on low or one low and one high yet? Sounds like there’s something more to the low voltage side of things....
Sent from my iPhone using Tapatalk Pro
ThreadI wanted to continue a conversation started in a ATF about people’s bedroom slide floor cracking where the rollers are creasing the coating. I ask as one end did this about 6 months ago, not the other send is about to break through a crease too.
Anyone else have this issue? Or has anyone...
I also hear a high pitched tone when the hot water heater is operating on electric only. Specifically when the heater is actually heating. Once it reaches temp, the high pitch sound shuts off.
Never caused a problem but is interesting.....
Sent from my iPhone using Tapatalk Pro
This was for good reason. Everyone with a fuel storage cell has it located back there. You do not want to capture fumes if there is even the slightest bit of vapor leakage. That would be bad.
Now if you ordered without fuel cells I’m sure you could do something more about it like insulation...
We picked up an amazon oscillating dual heat level heater. Adjustable thermostat and tip sensor. Works pretty good for $35. Just sayin
Sent from my iPhone using Tapatalk Pro
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.