Search results

  1. H

    Lippert Level Up Failure

    Dealer is unable to fix Lippert Level Up system! Originally I was unable to raise the two rear sets of jacks of the six point Lippert Level Up system on my 2015 Heartland Cyclone 4200. I called Lippert for technical support help. They emailed me a troubleshooting manual; was having freezing rain...
  2. H

    Ramp Door failure: Anyone replace with MORryde Zero-Gravity Ramp Door

    I've read several treads on Lippert Ramp Door failures caused by water infiltration due to the lack of sealing. From those posts when your unit is out of warranty it is obvious that Heartland and Lippert were of little to no help in resolving those failures. My 2015 Cyclone 4200 ramp has become...
  3. H

    Leaf Spring Failure

    The door side lead axle leaf spring on my 2015 4200 Cyclone (triple axle) appears to have flattened, a total failure! All other 5 leaf springs appear arched as you would expect. This unit was purchased new in '15. My selling dealer has since been sold and subsequently gone out of business. I've...
  4. H

    Cyclone-Couch material wear after 4 years

    Unit: 2015 Cyclone 4200. The five seat couch material is wearing off sooner than I would expect. I have attached pictures. Anyone else experience this? Any solutions or advice would be appreciated. Are there any better quality replacement furniture available? Thanks in advance for your time.
  5. H

    Seeking suggestions for Replacing 16" wheels & tires with 17.5" on Cyclone 4200

    Has anyone replaced their 16" wheels & tires on triple axle trailer? What did you go to? Any recommendations would be appreciated. Asking as over the past two years I have had 4 tires go bad on my 2015 Cyclone 4200; one blowout & three had ply separations (air loss). Several tire/wheel &...
  6. H

    Landing Leg angle on 2015 Cyclone 4200

    We have a 2015 Cyclone 4200 with the Level Up hydraulic leveling system. The left front landing leg is angled out (see pic). This is condition is certainly more noticeable when fully extended. There is no obvious frame bending or bracket distortion. I believe the mounting bracket was welded at...
Top