Search results

It was an option that sold for $125. I've never used it but there are numerous comments about this hitch, mostly if not all bad. Sent from my LG-M327 using Tapatalk

Are you wanting the factory installed bike hitch? Sent from my LG-M327 using Tapatalk

Thanks Gary521 Sent from my LG-M327 using Tapatalk

Both pedestals have the 100 amp main breaker. I'll be sure to bring this up when I talk to the installer again. I haven't purchased a unit yet so hopefully can find and make one work. Sent from my LG-M327 using Tapatalk

I forgot to mention that power isn't an issue as I would use this setup on a rv lot I own in Arizona and at my daughters in Montana where power wouldn't be an issue either. Both power pedestals are 100 amp with a 50, a 30 and a 20 amp receptacle. Sent from my LG-M327 using Tapatalk

Has anyone tried installing a residential min split ac unit in their trailer? I plan on spending the summer in the Arizona desert and my rooftop units can't keep up when the temps start hitting the high 90s. I've got a 42 ft Bighorn and am thinking of mounting an 18k btu compressor on a rack...

Thanks everyone Sent from my LG-M327 using Tapatalk

My fireplace is squeaking. Is the fireplace a sealed system or is there someplace I can oil the flame as it is the only part that rotates. Sent from my LG-M327 using Tapatalk

Channel Master makes a DVR OTA unit that works quite nicely. It's cheaper than TIVO and no monthly fees. I've had mine for a year and I'm very happy with the unit. Sent from my LG-M327 using Tapatalk

I've always used them. It really helps stabilizing while its windy and helps with some of the bounce from normal walking. I only use enough pressure to support and check them weekly or after a rain as I'm sitting on packed rock. Sent from my LG-M327 using Tapatalk

Pan with drain Sent from my LG-M327 using Tapatalk

Dually all the way, stabilty and safety. If you get a rear blowout with a dually, you'll be better equiped to pull over to safety. Sent from my LG-M327 using Tapatalk

Splendide 2100XC combo vented works great and fits nicely in the w/d closet. Sent from my LG-M327 using Tapatalk

Thanks for the advice Sent from my LG-M327 using Tapatalk

Maybe there is a better forum but I'm using my phone and maybe the admin can move it to where ever. Sent from my LG-M327 using Tapatalk

I don't mean to hijack but I'm trying to install a Spendide washer in a 3875FB. I bought the drain pan but where can I route the plumbing. To the best of my measurements, if I go straight down , it will come out on the overhang. Sent from my LG-M327 using Tapatalk

I've lived in my 2015 3875FB over 2 and a half years. I've never had any water problems related to the cold. I've been in the low 20s and I use the yeti system to prevent the tank and line from the pump from freezing. I absoltely would recommend this floor plan to anyone interested in a bath...

Sorry, forgot to add my name. Bob Scheett Sent from my LG-M327 using Tapatalk

Add me please, I'll have one guest. Sent from my LG-M327 using Tapatalk

I'm going to Samson because the local tire dealer couldn't get Sailuns. Why not try a different brand, maybe Samson will be better than Sailuns. Here's a picture of what I call scrubbed. Notice the inner and outer tread is gone. I've aleays ran the tires with 110 pounds. Sent from my...

I'm changing out my Sailuns after 4 years. They were pretty scrubbed on the inside and outside. I'm going to try Samson, I haven't seen too many problems posted here and other chat sites. Sent from my LG-M327 using Tapatalk

Thanks everyone, 120 lbs it is. Sent from my SM-G920V using Tapatalk

I have a 2015 Bighorn, gross weight 16,000. I've got the Sailun tires at 110 pounds. Question is, what is the recommendedd torque for the lug nuts? Sent from my SM-G920V using Tapatalk

I understand the dicor for the roof and front and rear caps. What about the caulk that holds the rubber D seals in place, the side molding, around the tops of the windows, over the cargo doors, etc. Sent from my SM-G920V using Tapatalk

What type of caulk should be used on the exterior? I know not to use silicon, but there is a siliconized caulk, an acrylic caulk, and of course the dicor self level and no sag. Sent from my SM-G920V using Tapatalk

In the truck bed with a cover Sent from my SM-G920V using Tapatalk

Should have been RCA in the bedroom Sent from my SM-G920V using Tapatalk

Mine came with a Samsung in the living room and a TAX in the bedroom. I have a 3875FB. Sent from my SM-G920V using Tapatalk

I have the 2015 FB3875, I've lived in it full time for 21 months and have had no major issues and only a few small ones, mostly cosmetic. Sent from my SM-G920V using Tapatalk

Call Heartland to determine where the backer plate is located. The lovely ladies will be more than happy to send you a diagram. Part of the wiring is in the roof under the blank plate. There should also be a control wire located near the antenna booster switch. Sent from my SM-G920V using...

Re: Having Awning Issue The same thing happened to me, if you use a little bit of soap on that nylon anchor Rod whatever you want to call it, it'll make it a lot easier pushing it back in and then what I did to keep the awning from shifting again, I put a screw in it the end. Sent from my...

Re: Macreator Questions X2 Dave Sent from my SM-G920V using Tapatalk

Here in Quartzsite from the campground, there is usually 6 to 9 Birds buzzing around up high. I don't think I've ever seen any of them pay any attention at all to any RV roof. They seem to roost in the tall palm trees, maybe that's what attracts them to campgrounds. Sent from my SM-G920V...

I use slide stabilizers. I don't use a king pin stand because I have a flex air pin box. I do use wheel chocks and three inch wooden pads. I have barely any movement except when the wind is blowing. Sent from my SM-G920V using Tapatalk

Here's some more pictures. Sent from my SM-G920V using Tapatalk

I'll get one tomorrow Sent from my SM-G920V using Tapatalk

Did you have a problem with part of the frame pushing against the front wall not allowing it to be pulled back tight? What would have caused this? Sent from my SM-G920V using Tapatalk

While moving stuff around inside the generator compartment, on each side the front wall is pulling away from the metal supports coming down. You can see where each side has a screw head already broken off. The bottom of the compartment is tight, there's no gap, it's just on the sides there...

I have a 2015 Big Horn, sure looks like my buckskin sofa and similar throw pillows. Sent from my SM-G920V using Tapatalk

South-western Arizona is pretty decent during the "winter months". Think upper 60s, 70s, and 80s. Sent from my SM-G920V using Tapatalk