Gate Valve's

Routemaster

Well-known member
My gate valves are not closing all the way so, also have dad some dribbles I am thinking that I might have the same problem as I did in the Everest that we had. Still not checked it out yet.
 

Attachments

  • Gate valve 1.JPG
    Gate valve 1.JPG
    643.9 KB · Views: 28
  • Gate valve 4.JPG
    Gate valve 4.JPG
    669.9 KB · Views: 28

mlpeloquin

Well-known member
They are usually Valtera valves. 3 inch for the black water and 1 1/2 inch for the gray. The cable in the rig can be removed by loosening the set screw. The standard valve is inside the outer holder. Everything unscrews. Hold the shaft with a pair of channel locks and unscrew the metal top. Hold the shaft of the new valve and unscrew the handle. Then screw the metal top on the new valve shaft and reassemble. It is that easy.

Note: Tilt your rig towards the drain and drain into a bucket. Put this in the sewer. If you have a sewer clean out use it, otherwise you can dump it down the toilet. Then tilt the rig the other way. This prevents waste dribble while changing out the valve. Do wear gloves!


3 inch
https://www.amazon.com/dp/B000BGK22E?tag=duckduckgo-ffnt-20&linkCode=osi&th=1&psc=1

1 1/2 inch
https://www.amazon.com/Valterra-T10...gate+valve&qid=1591747329&s=automotive&sr=1-3
 
Top