motor

I just purchased a 2020 Heartland North Trail 31QUBH a month ago. When I put out the slide out last week, I heard a giant popping noise. The motor came off the wall. (The screws holding it in place all came loose.) When the motor came loose, it twisted a couple of times on the chains, and then...

I have Everything installed and wired the 2 new switches in the propane compartment so i could run individual jacks at a time, and i also left the original rocker switch on the front of the trailer to run both jacks at the same time but heres where I've hit the wall all three switches are...

My wife and I bought a 2013 37 Ultimate and have been staying in it just over two weeks. So far here's what's gone wrong: Faulty GFI knocked out seven outlets Bad cable cord faulty landing gear motor two blown remote fuses ac condensation inside rv with sewer smell coming from ac without any...

I believe I need to replace the motor for the front jacks on my Cyclone 3795. Question is how do I gain access to it? Do I need to remove the generator and go in from the front door or can I take out the front wall in the storage bay and get to the motor. I took the screws out of the front wall...

For those of you who have never camped at Bristol Motor Speedway, it is crowded but it is FUN FUN FUN! Met some great people from Minnesota, Indianna, Missourri, and good ole Cherokee, NC (who owns a campground there)! It is definitely an experience!

When we started to leave the campground this morning the 40 inch TV in the rear of the 3610RE would not retract down into the cabinet. Checked all the fuses/breakers and they were good. Removed the TV from the mounting and checked all the wiring for any disconnects. Did not have my multimeter...

On My OTB TT if motor failed you needed to unlock motor before you were able to hand crank. Do you not have this step with a Sundance?

I read some post stating how the gear casing breaking on the landing gear electric motor. I took a look at mine and saw that the motor is loose and could bounce around braking the gear housing. I used a 2 3/8" pipe fence post clamp and a foot of 2" strap. (HomeDepot)

I was putting out the double slide when I heard the motor really start to slow down. Then I smelled something hot. The motor has quit. How can I check the motor and determine if it is the motor or whether it is a wiring problem. What is the warranty on the slide motor as trailer is just over...

I have a Bighorn 3055rl and the motor for the landing gear gets very hot while operating. Do they make a bigger motor?

The front landing gear/legs on our Cyclone fifth wheel would not work when we arrived for camping three days ago. We discovered that a screw had sheared off and the connecting rod would not turn. We were able to replace the screw and nut, but it appears that the motor for the gear is loose...