I've gotta tell ya, I probably shouldn't be posting right now, I'm so mad I could chew nails and spit tacks! I bought a 2009 3110DS and was getting ready to take it on the 2nd trip. As I raised the landing gear to the stop the right one falls back to the ground! I try to raise it but the switch is dead, So I start digging and find the 30amp fuse blown. I proceed to replace the fuse and now just the passenger side jack works. Of course I'm hooked up to the truck and now have a one legged set of landing gear. After digging 10 plus inches into the dirt to pull the bad leg out I find the Gear has sheared off the pin at the top of the leg. I put in an emergency call to lippert. Lucky for me they call back but with horrible news. I need a new Jack! He says there's a slipper clutch and a shear pin to protect the drive gear. How in the H E double toothpicks does the main shaft still manage to break off at the gear??? I cannot believe that: 1.there's not a limit switch to this system. 2. The shear pin didn't protect it. and 3. the fuse didn't protect it. Now what am I supposed to do?
Very Frustrated in Colorado
Very Frustrated in Colorado