Recent content by 2psnapod2

That is correct. The Lippert One Control only controls the Level Up System only. The KIB system controls the rest of the items you have mentioned. That is why it would be nice if it had more functions available to it. The way it is, the One Control is rather useless as the original controller...

Dan, they have both. But it does have the older style KIB system.

Just drill a hole on each end. Sent from my SM-G975U using Tapatalk

Yes they are supposed to have about an inch of camber to them. A good way to tell if they have lost their camber is to tape a small string to each end by the springs. You should have about an inch of space between the axle beam and the string. Sent from my SM-G975U using Tapatalk

The axles are added after the fact. as the Frame is Built by Lippert and the axles are from Dexter. So I doubt they were flooded. Maybe some rain or snow that melted. Not sure what time of the year your trailer was built. I have not heard of any flooding that happened to either Heartland or...

I would seal the upper holes where the wires are, but by leaving the lower ones open, but painted without sealing would allow for any water that is in the axles or drain out of them, to drain. Stopping the water from going into the axle tube would be best.

Mark, you have a issue that is unusual for sure. I am not an expert on axles, but do upgrade many RVers with larger axles. I would drill a small hole in the bottom of your axles to drain the water. Maybe 1/8 inch or so. I have seen many people drill into their axles to support steel brake lines...

Dan, do you know where these 4 wires go? I have the older (2019) KIB system. I had unhooked them when I took my water heater out to fix the platform it was setting on. They used a couple of 2x4 pieces and a 3/8' of OSB to put it on, and it was caving in pretty bad. So I pulled the water heater...

Thanks Dan for the help. I did see that on the manual in the HOM. I did disconnect some of the wiring and was wondering what exactly the box that is always attached to the Water Heater with a zip tie was? It then has 4 wires going somewhere. Wonder if anyone has any idea as to where they go?

Has anyone had any luck troubleshooting the water heater with the KIB system with the water heater not working on electric?

Re: Circuit Breaker Orientation (Wiring) Following. Sent from my SM-G975U using Tapatalk

Performance Trailer Braking can beat that price. AND THEY ARE A Heartland owner also. Sent from my SM-G975U using Tapatalk

I fixed my bubble by slicing the roof material mid way. Used the glue I posted earlier to glue it all back down and added some staples. Then covered every seem with the 6 inch roof tape. Did it in abour 4 hours total once I received the materials needed. Sent from my SM-G975U using Tapatalk

That is what I used. Sent from my SM-G975U using Tapatalk

https://www.amazon.com/dp/B003VAXDSW/ref=cm_sw_r_cp_apa_i_u16dFb1HB1ZCY Sent from my SM-G975U using Tapatalk