Recent content by ejered

i have successfully loaded 2 banshees a 400ex and a rhino in the garage of ( 1 banshee stood up in front, rhino pulled in behind it against right wall, 400ex and other banshee stood up against left wall,....sorry no pictures but will give you an idea of what is possible...

Under my 2008 3912 the other day and noticed something that just didnt look right hah, Im glad i took a crawl underneath it before my next big trip this week because what i noticed was not only a recipe for disaster but catastrophic failure and a very poor design for a trailer rated at 18k lbs...

The front landing legs have alot of issues. Contact Venture Mfg. At (866) 365-1957, they will need ur serial number (under the top cap of landing leg) and can send you a repair kit or whatever parts you need. My thought on the dual conversion was to reduce the loading on the single drive motor...

Sounds great will do! The new reduction boxes or updated reduction boxes are made of aluminum, well the cases at least.

I swear you guys are amazing hit the nail on the head! That is exactly what I was looking for, this site is the best thing a heartland rv'er can ask for! Thanks guys greatly appreciated! Happy Camping! Jered

Took a quick gander at it tonight and the adjustable "syncronization adjustment" was completely loose allowing it to be in the most outward adjustment on the rear end. This must have been the pop i heard. so i pushed the slide in and tightened the bolts back up and now it pulls the slide in...

Soo Long story short after dealing with numerous issues with front landing gear and constantly having to assist the motor with the handcrank, i have come to the conclusion that the motor just does not cut the Cyclone 3912 weight. It always seems as if it is struggling while hitching/unhitching...

Bob from what I can see without removing underbelly (yet) looks like mine is set up the same way with the ram in front and rack and pinion set-up on both sides with a square crossbar, i did notice that the cleRance of the slide is way too low on the bottom rear cause it to rub and cause damage...

I believe something is wrong with my kitchen slide (ods side). I am very mechanically inclined and am wondering if anyone has had the same problem or issue or knows what could have happened or where to start. It seems as if the ODS Side Kitching Slide Out is only being driven why the front...

Got them in mine too and actually had to straighten them out they were crooked

This is exactly what happened to my unit, and yes i believe they do offer a new one made of aluminum as the dealer stated the new one is updated and made of aluminum instead of plastic, buckeyebob it may be worth researching as this happened in my driveway, i couldnt image it happening away from...

I also would be very interested in this??? Doesnt seem as if it would be too tough to accomplish?

Thanks I will most definatly do that! Seems as if they have fixed this problem with the aluminum motor case for the motor, Im sure it has been discussed previously, Thank you both for your help, as lord knows im not quite the most experianced rver ha

Perfect just got off the phone with the extended service rep and they have changed their mind and decided that it is now covered. Thank you for the advise. The new motor case is made of aluminum and not plastic! Thanks again, I love the site!

:mad: 2008 Heartland Cyclone 3912 Ok so hitched my trailer the other day and Landing gear motor sounded as if it was straining then popped. Upon Inspection keyways and all attached drivetrain was in tact, it appeared as if the actual electric motor case that holds it to the jack post has...