Recent content by ENG2242

Pole one on the Hughes Protector is tripping. I've narrowed it down to the front AC. I've pulled the cover and the compressor capacitor looks fine. However, the fan capacitor has one burnt wire. I don't have a meter to check each one. I'm hoping the compressor itself isn't fried. 1- Could it be...

Does anyone have any suggestions to get the electric schematics for my 2028 Bighorn 3870. I need a full diagram, and also assume the charger is located in the rear underbelly. As it’s not in the garage. My mechanic came down and test all electronics, and I’d requesting the schematics. Thanks David

Yes sir, your analysis was correct. The tank has dropped off it’s angle iron supports on both sides and has dropped 3-4”. Even worse is one side is bowed in substantially. I have found a reliable on site RV tech, I honestly think I’ll be purchasing a new tank. However, he did discuss how...

This is the leak between the valve and the tank. I’m not certain how their connected. The hose strap is tight. Sooo, what and/or how is it connected that could cause this leak? Thanks so much: David

Hi, I have an intermittent leak under the front underbelly, indicated by an occasional drip coming from the front underbelly. I had to make a small cut in the underbelly in order to let the water drain out. (Not a lot, enough!!) I let the black tank get full ( pressure??) and did laundry today...

Thank you sir, I’m looking at it and have no clue how to access it in order to clean it.

“Then electronic circuitry”

Thank you everyone!! First I do have pet’s, so cleaning will be the first step. The electronics. Best wishes!!

My electric fireplace will only blow heat for a few minutes the the heat shuts off. This is regardless of the settings. Any input would be helpful!! Regards, David

It’s gotten cold here in St Louis, however, the temperature has warmed up enough to thaw the drain pipes. Originally, the black tank valve was frozen, and would not budge. Since it’s warmed up constantly for a few day’s, the valve opens freely. However, it’s not draining. I have tank heaters...

How do I adjust my Sundance awning so water doesn’t pool up? Thanks for your input. David

My Furrion oven won’t stay lit after multiple attempts. Seems every time I light it and close the oven door the flame goes out. Thanks, David

I recently was in a flash flood. Water entered in the lower front of my rig, dropped the under belly, fortunately no damage. So to my point: If I wanted to override the leveling stabilizer, and lift the rig front and back to their highest point. (I.e) lifting the rig off the ground; how do I...