Can someone recommend a good salesman at Ron Hoover dealership. Thinking about trading my 2011 3450TS for a new one. The dealers in the Dallas / Ft Worth are not stocking them. Spoke to a salesman on Friday there and he was just clueless.
Ken
Re: Unexpected Outstanding Service
If you purchase a new vehicle you can go to your local Discount Tire and buy road hazard on your tires. I should say that was policy 6 years ago. I have not purchased another vehicle since then, but I have done this a couple of times.
Thanks for the info guy's. I did receive a reply from the factory and they said that it was 12' - 11". But I did go down to the storage lot today and measured it myself and it is 12' -11". @ Ray I do have the low profile A/C in the front.
My 2011 BC 3450TS is in storage a couple of towns away and I am needs some info on the height. The literature says that it is 12'-11", but does this include the air conditioners. I have both front and rear A/C's. I am looking at renting a covered site in AZ in a few weeks that is 14". So I was...
I was getting a little worried that we were going to have to cancel. My unit had been in for some service since we returned from Colorado at the end of August. I picked it up this morning. Nothing like getting close. I kept telling them that we were going to this rally.
I had the same problem with odors being pulled in the A/C unit from the black tank vent depending on which way the wind was blowing. Installed a Cyclone vent cover and problem solved.
The first time I took out the prior 5th wheel I had, I dropped it on the truck. No damage to the trailer but sure bent up the side rail of the truck. Waited until after the summer to have it repaired. Was always a topic of conversation in the campgrounds all summer.
No the main A/C has ducts in the bedroom. I have 2 vents in my bedroom from the main A/C. This way if you only have 30amp service you will still receive A/C in the bedroom. Or if it is not that hot you only need to use one A/C.
What I did when I installed mine was to take the cap off the vent. Then I trimmed the inside of the cap in order to allow me to slide the Cyclone Sewer Vent inside the cap over the pipe. Then used the set screws to secure. I then cut a Dicor patch to size and wrapped that around the tube to fill...
Was having an issue with odors from the blank tank being sucked it at times when running the 2nd A/C unit. I installed a cyclone brand vent in June and solved the problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.