Hi:
My Fuel 250 has it's 2nd 'touch' type thermostat. I'm not a fan of this thermostat,
it's tough to use as it doesn't always register the touch, etc. I'd rather one with
mechanical buttons.
My issue is this - In the summer, several times I didn't touch the thermostat, but it
would go off...
Well, I finally got around to trouble shooting it. Turns out it's the wire from the switch to the controller.
I was able to move the bed both directions by jumping the switch connectors to ground first, then by
using a cable I made up between the switch and the controller. I also redid the...
I'll double check the chain but I would think if it was jammed I'd blow the fuse (Like I did
when I overrode the down) (It's all the way down).
Thanks for all the advise though, everything helps.
I supported the center of mine also with 2 clamps made for sewer hose holders so it's supported by the edge and two other spots. It doesn't move on the door.
This is on a FUEL-250.
I was supposed to go on vacation the end of this week so I went out to
the trailer to prep it to load my Spyder (3 wheeled motorcycle) and
the bed was dead up/down. Checked all the fuses, seemed ok.
On the plus side, that trip has been cancelled for non FUEL-250...
I put that very one on the back door (bottom) of my FUEL-250. I first tried mounting it on
the left side up front. (I attached another metal arm way up front to support it) but it was
closer to the generator exhaust than I wanted. Eventually i want to fabricate a side to side 8'
one that goes...
This is the first time I've used 'stands'. I always have used simple wheel chocks but strapping the bike in requires a lot of
finesse, or a 2nd person. I put the inserts in for my Stainles Steel Chocks (I have 4 in a 4 place Snowmobile trailer), then
decided to put the self locking chock/stand...
Ordered a replacement (Thermostat only) - Unfortunately after I saw the bluetooth comment. :)
Installed it and it works much better than the old one. Much more positive pushes.
It already does have the little foam things inside the buttons. Sometimes I need to press many times
to get it to do something, sometimes on press and it seems to stick.
I was hoping it was a simple thermostat and not an electronic head to a control unit (as it seems like
it is now) so I...
I've now grown to hate the haunted electronic thermostat in my FUEL 250.
I want one with a separate heat/cool and fan (auto/lo/high) switch and then
a temp adjustment. Ideally non battery powered. I know I can look at
regular thermostats but am looking for recommendations from folks.
Anyone...
I have a fuel 250 and did two trips with a large Indian bagger and a VROD with bags. I used 5/16" threaded inserts 1" deep (the floor thickness). Over
the wheel tie downs it's thicker. I got them on Amazon and they came with my chocks. I used a smaller (not free standing) lock chock from
HF...
Does anyone know if you can get a heat strip for the 15K base A/C unit?
I can turn on the A/C fan with the heat (No compressor) which makes me
think they may make one.
I have one on an old Lance Slide in I have and it works great for mild weather. Draws
about 1250 watts and only outputs air...
Anyone know who makes a 72 or 76" ladder? I tried the one above and it didn't even reach the floor. :O) I extended it to 66 or 68" (See pics) but it's not quite at as much of an
angle 12" away) as I'd like and the first rung is now 'wicked' high. :)
I can easily make the ladder higher but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.