I have a 2015 Bighorn 3010RE- Just getting it going for some guests and I can't get the water heater to work. The strange thing is that the anode rod was pretty warm to touch but I'm not flowing hot water on Propane or electric. The ignighter won't even try to start on propane. I opened the...
I noticed while replacing all my brake assemblies that my front axle wheel locks up while I can still turn the rear. I taped my manual RV brake on my controller on max and both wheels lock up. Brakes have been adjusted. Just wondering if this is normal.
Just did 3 coats of Decor on my 2015 and now have it in my new RV garage so thankfully it will not sit out in the blazing sun or weather anymore; at least not until we take her out again!
I have a section of plywood sticking up under the rubber roof and am about to recoat the roof. I would like to screw the plywood back down but would like to know where to drill?? Anybody have a link to roof construction.
2015 3010re
Just an update- Turned frig off for two days and now working as before. Temp set #2 and frig at 32 degrees. I did originally change thermistor with no change then unplugged it altogether. Bought another thermistor and installed and working fine. So not sure if there was a bubble in the ammonia...
My 1210 suddenly stopped cooling 100%. The freezer gets cold as well as frig but not below 50. Before this it would get to 32 degrees on level 1. I unplugged thermistor and replaced and unplugged and it’s not cooling down. I have added several fans inside and out which had it working great until...
Thought I would share some help instead of asking. My Norcold refrigerator would typically run on level 7 for cooling. I noticed one of the exterior fans wasn’t working and found no way to replace it easily. I installed two fans on the vent cover (YouTube);found a 150 cfm (about double stock...
Looking for suggestions on a safe exterior treatment for removing mold on slide tops. Staying in TN and dealing with rain and high temps have made my slide tops a petri dish for mold. I have about two months before our home and RV garage is done.
The capacitor was it! I had already bought one but then found a loose wire. I think the loose wire might have played a part in weakening the capacitor over time. Blowing nice and cold now!
Thanks everyone!!
I had an E-1 code and found a loose wire which solved that problem but I can hear the compressor kick on and off every 15 seconds or so and not running long enough to blow cold air. Fan blows continuously. Could it be a capacitor issue? Fan is not dirty!
For those of us not prewired (2015) is it just a matter of drilling hole and running wires to running light and driving with lights on? It’s about time I get a camera I will be backing into garage soon!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.