Recent content by SLO

My reasoning for considering there is. While towing it’s hard to tell if you have a balance problem in the trailer wheels. I’ve had some uneven wear patterns that nobody can diagnose for certain. If a tire is out of balance it can’t have an even wear pattern (at least my small mind doesn’t think...

Thanks for posting this….I think. Now I’m looking at these for trailer and truck. Sent from my iPad using Tapatalk

Since there’s a check valve after pump and one at the city water connection, you could have weeping on either. Expansion tank needs to go on cold line. Sent from my iPad using Tapatalk

With everything you’ve done so far it seems clear thermal expansion is your problem. As the water heats it expands in the water heater tank. Normally water heaters are designed to expand into the incoming cold water line. Our RVs are a closed water system. The check valve in the incoming city...

Here’s a link to a thread I posted 6 1/2 years ago. I still stand by it. https://heartlandowners.org//threads/heartland-bighorn-quality.72903/ Sent from my iPad using Tapatalk

Breakaway switch? Sent from my iPad using Tapatalk

Your Accuslide cables are way, way out of adjustment. Surprised chain hasn’t come off the sprockets. In 2179.jpeg you can see on the green block the chain connection is at the very end of the adjustment bolt. My guess is the jam nuts weren’t tight allowing connections to loosen up. If you’re...

All the legs should touch the ground. If the site is very unlevel you may need to manually level it. If extremely unlevel you may need to put blocks under the leveling pads. Or, as I would do, find a more level site. If the site is reasonably level and your auto level is acting this way, there’s...

If the water in your drain tray is freezing or anything else in your frig, you have the cooling level set too high. Nothing should freeze in the frig. I look at mine every morning and adjust cooling level based on the temp in frig and ambient temp. These are not like home refrigerators, you have...

https://www.homedepot.com/p/Fernco-4-in-x-4-in-PVC-DWV-Mechanical-Flexible-Coupling-P1056-44/100372298 You have to determine what size you need. Sent from my iPad using Tapatalk

I have used our Splindide washer on the inverter, but. I usually turn the breaker off to washer when we’re on inverter. Because I’ve had the washer make clicking (off and on noises) sometimes when the inverter kicks on. Sent from my iPad using Tapatalk

Ours doesn’t have a seal. Sent from my iPad using Tapatalk

IF you’re sure the detector only sounds after stove or heater had been on for awhile, then it’s not a pressurized line leak. Meaning checking the lines before the stove or heater is useless. If it were a pressurized line you would have to LP detector sounding all the time. Sent from my iPad...

Congrats on the new trailer. Hope you get many memorable trips out of it. Welcome to the Heartland family. Sent from my iPad using Tapatalk

https://www.farnell.com/datasheets/3740642.pdf Different part number than yours. Just for connecting wires together. No fuse. Sent from my iPad using Tapatalk