Recent content by Thadandrachelb

Like the original poster, I overfilled my fresh tank. I now have intermittent leaking from a hole in the coroplast, which I am assuming was caused by my carelessness. I cannot find an obvious place where leak is coming from via basement access panel. I'm thinking I will need to look behind...

Thought I'd close the loop on this just in case it's helpful to anyone. After looking at the Ultra-Fab and Bulldog products, it looked like neither one would fit. I got the best information on this from etrailer.com. I found their online help desk to be very useful. Here is the link where they...

Gary, I did hypothesize at one point that the leg had just slipped in the bracket. But after removing the leg, I can actually bang the foot on the ground and get the leg to retract. Something is seriously slipping in there. I didn't mention this in the initial post, but the previous owner would...

Replying to my own thread as I learn more. Ultra-Fab says I'll have to weld them on. That seems nuts to me, but I assume they know what they are talking about. Now I'm researching the Bulldog dual motor system, which is supposed to be bolt-on. Again, I don't want to be drilling holes in the...

I recently purchased a 2009 Cyclone 3950. The seller replaced a broken landing gear leg on the driver's side before I took delivery. The new leg broke the next time I unhitched. I actually had the pin weight off of the fifth wheel and was about to pull off when the leg completely slipped...

Brian, Thanks for the response. I would actually love to buy a Ford for several reasons. It's just that I'm very hesitant to do so based on the 6.0 reputation. I have read some articles about making improvements to the 6.0 to correct some of the design flaws and turn it into a dependable engine...

I'm planning to buy a Cyclone 3950. Don't yet have a tow vehicle. Trying to decode the towing riddle. I plan to pull this thing out west, but there's no way I'm getting a semi. I'm looking at the towing guides from www.trailerlife.com, because they show the towing limits for all manufacturers...

Thanks all for the advice. I've decided to pass on purchasing this unit. I think the delamination issue is not a major issue on this. However, it clearly affects the value and resale potential. I'm new to the RV buying business, so I just want to be super cautious. If I knew more about it, I'd...

I am negotiating on a 2008 Cyclone 4012. It is at a car dealership who took it in on trade. They have it listed for around 35K but made me an offer of 29.5K. That seemed like a pretty fair price. That's below NADA's low retail. I accepted the offer with the contingency of having it inspected at...