Recent content by Yianni

Ah, if only it were that simple. That was my original thought, this is going to be easy but it would be too difficult. The ducting for the heater is in the upper underbelly section not visible when you drop the underbelly and then there is a gray tank mounted below the ducting making it pretty...

Ronn, Take a temp reading at your register and see if you are getting anything close to the 86.3 I had on mine. Even with 4 inch ducting 86.3 is not close to the temp coming out of the other registers but keep in mind the other registers are supplied by sheet metal ducting and not flex hose...

Best of luck to you Duane and Deb. We'll keep our fingers crossed everything works out well and keep you in our thoughts today.

My 2010 Cyclone 3010 has exactly the same condition you described. In my case, the fit and finish on my trailer has been excellent from the beginning except for that alignment, so it really doesn't bother me much. I don't think adjusting will bring it in enough to match. The slide is tight when...

I drove from California to Ohio to buy my 3010. The savings were quite substantial and the family flew in to New Mexico and met me on the way home for the Balloon Festival so it was a great family trip too. I also enjoyed the drive to pick it up. I saw many states I probably would not have...

Very impressive setup. I wish that $2400.00 deal would come up on the west coast sometime. That would be my Christmas to myself.

Wow, that is a very generous offer. Kind of you to think of everyone here. Can you hang on until 2012? I think that's when I'll sell my 2008 2500HD and go for a 3500HD SRW.

Duane, Good thing these things are (fairly) small annoyances. Still stinks though. I have a question. Does your level up auto level with the touch of a button? I thought I read Quadra's Bigfoot claimed they were the only ones with auto level.

I believe this is the new set up. It looks very nice.

I have a 2010 3010 and it came with an A/C vent in the garage. We found this last Summer when we were in Red Bluff (108*) the A/C unit did a pretty good job. We found the bedroom gets very cool from the factory installed vent. My wife was getting too cold at night. I'd rather have a second A/C...

Well, to wrap this thread up from my original post, I talked to Heartland parts about doing the conversion. Sandy Horn in parts did an outstanding job of researching what would have to be done. Unfortunately, we hit the $3,000 mark and were not even done. I think for that amount of money I'd...

I have a 2010 Cyclone 3010 and wanted to convert my rear beds to the new design. I called Heartland parts dept. and Sandy Horn answered. I explained to her what I wanted to do. She admitted she had only been there a few months. I thought, oh boy, I know how this is going to go. She said she...

Shagan77, I'm attaching a couple of pictures of the current bed and table setup. I think the bed setup that had the 4 -6 inch gap was pretty short lived. Same with the plastic folding table. You could modify your Cyclone to the new table setup pretty easily. Just drill 3 holes in the floor. I'm...

Duane, Really sorry to read this. They become a family member and bring you so much joy over the years it's very hard when they're gone.

I think if he had let a little air out of his tires he might have cleared. http://billingsgazette.com/news/local/article_929b8994-bac7-11df-9bf9-001cc4c03286.html