Search results

Any suggestions for replacing the powered recliners with something that can be converted to a bed, and with more underseat storage? Given the lack of pantry space in 3110 could really use more underseat storage. I'm not a fan of these recliners the motors failed within months and seems there is...

Thanks for replies and suggestions. It was easy to check underneath and see the frame running front to back. So additional tie downs can be installed anywhere on the same line as existing, exactly what I needed to do. Even with fuel tanks back there the frame is visible from underneath. I put...

Here is a diagram I just made that shows where I would like to put additional tie downs. And is there a recommendation for what brand tie down to use? Sent from my SM-N950U using Tapatalk

I am planning to order a beast rack for securing motorcycles in the garage, the rack attaches to floor tie downs allowing it to be easily removed. I have a stacked washer dryer that prevents me from using the front most tie downs, so I am thinking of installing more tie downs about 30" back...

They are probably wondering if you have 5th wheel (pin), or a gooseneck (ball in truck bed). If you attach a photo of your hitch/pin box we can tell you which you have.

I am happy with goosebox I recently installed on my Cyclone 3110 which I pull with SRW RAM 3500. Rides much better than the stock pinbox with solid 5th wheel hitch. Not sure how it compares with other pinbox or hitch that has air bags though. Only complaint I have is little more difficult to...

Confirmed. This chain will work with Reese kit. 1/2 chain rated for 45,000lbs. That should be enough [emoji6] https://www.etrailer.com/Safety-Chains-and-Cables/Fulton/FCHA0070324.html

Sure not smaller necessarily, but your curt hookups do look more like loops that would better accept a chain hook. On the Reese they are not really loops more like ovals and wider. I just ordered some larger hooks with chain from etrailer the website states will work with Reese ball kit. I'll...

Looks like a good kit, wish I would have got that one with the smaller loops would have worked with my chain hooks. I considered using the same kind of link, but the ones at hardware store were only rated for 2000lbs, I was afraid that might snap if chains were needed. They had larger hooks...

Use chrome and open "incognito window" that will give you fresh session with no cookies.

Also with my goose box order from Etrailer I I got the Reese ball kit and safety chains, but the hook on the chains will not attach to the puck hookups in the bed, I have to take the hook off to get the chain through the loop. To use these hookups I would need a much larger hook and then a...

I ordered mine from etrailer and it arrived in good condition on a pallet about one week later (I'm in Los Angeles). Free shipping, by freight company.

I have been using a winegard X1 for past 2 years and worked ok but problems with signal if cloudy or not a perfect view to the south. Main issue was only able to view one satellite at a time a problem since I have 2 tvs. Just installed a Travlr last week and while I have yet to actually connect...

Confirmed the H25 is the best receiver for SWM system (new Travlr). Having the receivers delivered next week same time they are setting up system in my home. BTW word of advice if you are getting Directv DO NOT call ATT/Directv directly and use their installers. Having waiting 3 weeks thru 3...

Yep I agree, maybe not for smaller trailers, but for 10k+ disc brakes should be required there is just no comparison. The original drum brakes on my twin axle Cyclone were worthless and could barely feel them. Be sure to make this your first upgrade! You will not regret it. I feel so much safer...

Switching from Dish to Directv now that the ATT bundle with wireless is too good to pass up. Will be installing Winegard Travlr later this week. Seems I can buy H25 outright online for about $125, but going to check Directv too. Question is the H25 best current receiver? I am not interested in...

Have about 600mi of driving now after installing the goosebox and like it so far, no longer get that slamming or chucking I guess it's called when there's a dip in the road and while truck is going down trailer is still going up then it comes slamming back down. Did seem to notice a little more...

After working fine for almost past year, motor didn't work again today. This time the slide was all the way out I was trying to retract it, so I could get to the motor and found it was getting power. Tapped on the motor with a hammer a few times and voila it's working again, but for how long I...

Yep it was the switch in the front panel, I just flipped it on-off and the light went off :) hooray! I still have issue with my fuel pump switch I have to push it few times to get the timer to come on. Probably need to order some spares. Sent from my SAMSUNG-SM-N920A using Tapatalk

I got the 20k one, ordered from etrailer. I was very happy with how precise its built slides right in and all the bolt holes lined up perfectly.

Thank you! Ah yes, the mood lights I completely forgot about those! Been a while since I last used the awnings due to wind and weather. Finally time for me to label my switches I think :)

Doh! Thanks I hope it's that simple just my stupid mistake!! What are the 2 switches with the speaker wire for? Sent from my SAMSUNG-SM-N920A using Tapatalk

20k goosebox arrived this week, and I installed today. No issues the goosebox lined up fine, as it recommends in instructions I installed one hole lower than the pinbox I took off. Clearance is good. I installed it myself by using a floor jack in bed of truck to raise it into place. It is heavy...

Hmm thinking some more about this I don't remember turning this light on, does someone else with Cyclone know is the switch for this rear driver side light in back, or in the front panel? As I recall it's in back but it's odd that there are 2 switches with speaker wire on them. Maybe they go to...

Cyclone has been in parked for past 2 months, pulled it out yesterday and turned 12v switch on and noticed the rear driver side scare light was on. Thought hmm I must have left the switch on, but checked inside and switch is off. Parked it at the house for couple days and light stayed on entire...

In case anyone else is wondering, Cyclone has 1621HD pinbox. Since pinbox is rated 18k, I am ordering 20k rated one.

I have decided to go with Goosebox. Anderson hitch is interesting option too, but I am hoping the air bag/shocks in the Goosebox will help with the chucking. Went to eTrailer to order but looks like there are 3 different options depending on the pin box. Anyone here know which pinbox is used on...

Thanks. If I could get 4-6 hours TV time off inverter with my existing 2 batteries I would be happy. I have satellite receiver too that probably pulls about as much as the led TV.

Wow I see now why Magnum is inverter of choice, after reading specs for it, and learning it has transfer switch and charger built in. I am going to wait then until I can afford this option. Until then will just buy a cheap portable inverter and run extension cord to the TV :)

Thanks I'll check it out. Was hoping to just use existing batteries. But I am discovering this is not an inexpensive upgrade... To do it right.

Thanks for offer, it's fine here the answers from others are helpful, so busy yesterday didn't have time to check and reply.

Hi I'm considering installing inverter in my Cyclone so I can power some electronic devices without needing to run generator. Don't need to run microwave, just want to power tvs and satellite receivers, cell phone chargers. I would like this to be integrated into 120v main supply. I have 2 12v...

Thanks! We left on Saturday to drive back to LA, one day earlier than planned but I wanted to make it back down the grade before possible snow on Sunday afternoon, only to find Grapevine and 58 closed Sat evening. So we spent new years eve at Walmart in Bakersfield :) Easy drive down I5 this...

Hi All, thanks for the advice. Arrived last night. Exited 99 in Merced and took Snelling rd/G St. Up to 59, then picked up 120 at Keystone. There is bridge work on 120 after Chinese camp over the lake before priest grade they close the road at 5pm I came through about 3:30 at that time...

Looks like 59 is OK :) http://www.irv2.com/forums/showthread.php?t=259766

I suppose this would be the safest option but adds 40miles over Merced/59, 60miles more to avoid 49 (which after your feedback is a given now).

Thanks I'll go new priest then! And will avoid 49. Any thoughts on 59 thru Snelling and LA Grange? I zoomed in on Google don't see any hairpins... But I would not want to get up that way and encounter low bridge.

Thanks for noting that, I was not even looking at 49 but now I see that's very windy too :( OK so it looks like I would need to go thru Modesto which is adding a lot of extra miles and at least one more hour, but maybe a shortcut turn off 99 at Merced and try what looks like a relatively...

I am driving from LA to Yosemite lakes RV Park tomorrow and Google is telling me to take Greely Hill rd from Coultervile but this looks like pretty windy route. Is this safe in 40ft 5th wheel or should I head little further north to NEW Priest grade? That looks windy too, but I have seen posts...