Re: Dometic 2652 in Mallard M33 - Works on electric, not gas
Resolved. Got the diagnostic manual. Loose 12V on the gas solenoid.
Sent from my iPhone using Tapatalk
Re: Dometic 2652 in Mallard M33 - Works on electric, not gas
I suspected that battery was weak or bad. When I got the rig and checked the water level in the battery, it was low, plates exposed. Refilled with distilled water.
Anyway, I disconnected the shore power and the battery leads...
Re: Dometic 2652 in Mallard M33 - Works on electric, not gas
Funny you mention the heater/furnace. I didn't know the furnace was separate from the A/C. Just assumed reverse cycle. Oops. Anyway, when I switch the thermostat to heat, the relay in the thermostat trips but no heat. No blower. As...
Re: Dometic 2652 in Mallard M33 - Works on electric, not gas
Did not blow the fuse.
Bought pre-owned from private seller. We ran through all the systems from a standpoint of how each worked and how to use. Didn't think about or know enough to wait for LP side of fridge to cool down.
Sent...
Looking for some help again. I'm a very mechanically inclined newbie that just bought an M33. Fixed the water heater that wasn't heating on electric due to a missing wire nut. Now I need to fix the fridge.
The fridge works perfectly on electric, but not gas. Tanks are both full. Lines are...
SGeohagen, you nailed it. The wire nut connecting the switched 12V to the water heater was gone and the wires had parted. Crimped them together and I have 12V at the water heater now. Thanks again for the tip.
Now on to why my fridge won't run on propane but that's a different post.
Thanks danemayer - I thought I was going crazy missing that switch.
SGeohagen, I'll pull off the control panel and take a look. Thanks for the tip. Having always been in the boating world, it's seems crazy that they use wire nuts but I did notice them in some other places.
Newbie owner looking for home help with a 2016 M33. Picked this rig up a few days ago.
It has the Attwood LP/electric water heater. Works fine on LP. When I turn on the electric switch on the control panel, I get no hot water. The switch does illuminate. I cycled the breaker, no change...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.