Search results

I have considered the wire mold but that would be the last resort. I just don't like the way it would look on a smooth ceiling.

There is only one roof vent in the bedroom and one in the bathroom. There are two 12 v lights in the bedroom ceiling and a switch on the wall. As said the problem will be getting power from the wall switch across the ceiling to the fan.

Our 2015 Sundance 277 RL has only a vent in the bedroom. The vent is made by Lippert and has an internal dimension of 13.5” X 13.5”. Is there a replacement vent with a fan that is made for that size? Next question is how would I get 12 volt power to the fan? Any suggestions would be appreciated.

Yes, It is a Sundance 277RL XLT 5th wheel. Sorry about that.

My camper is a 5th wheel and there is room to elevate the pin box however space between the top rail of the truck bed and bottom of the camper becomes an issue if I take that route.

I could just replace the tires with the original size but I would like to raise the back back of the camper a couple inches since when towing I'm about 3" high at the nose. Additionally the clear coat on the original rims is flaking off so I thought this would be a good time to replace the wheels.

I am looking to replace the 225x75R15 size tires on our 277 RL with 235X80R16 size. I want to replace the wheels to. Question is how much clearance should there be between the top of the tire and bottom of the camper? What is the minimum space between the two tires? I am trying to see if there...

Would Heartland know where it is located? Sent from my iPhone using Tapatalk

Hi have looked all over for the pump.I want to check the fluid level in the reservoir and determine how it can be manually operated in the event of failure.

There is a shaft underneath with a gear track on each side with a long shaft on one side. I assume it is hydraulic. Sent from my iPhone using Tapatalk

Just went out and looked and the slide walls are very thin so I don't see any way the motor could be behind the fascia.

it might be a little tricky getting that off but I'll have a look

Hi, which fascia are you referring to?

Hi, Dose anyone know where the L/R slide out motor is located on a XLT 277 RL ? Any help would be appreciated

Mine are worn on the outside about 1" in

Just curious, Dose anyone know where the Sailun's are made?

The trailer seems to track pretty true and dose not lean to one side or the other.

Hi, I new to the forum with a tire question. Both tires on the right side of of our trailer have excessive wear on both outside shoulders to about a quarter of the way into the tread. The shoulders are worn down to about 20% while the rest of the tread is about 80%. The tires on the other side...