Search results

We have a 2010 cyclone 3950 and I just discovered that our water pump has failed for the third time. Each of the previous times the pump was replaced at no cost. Of course I had to install it but it is not much of a problem. Last time I thought that maybe some elbows were causing the problem and...

Working on the problem Bob I am the guy that picked up a rig similar to yours. They were setting side by side at the dealer in Ohio. I have posed this question on another thread and next week the local weld shop is going to do some modification to the pin box to try to remedy the situation. I...

Here are some pictures of my problem. As you can see we did make some modifications to the cover.

I talked to B&W yesterday and they acknowledge the problem. They say that GM raised the height of the truck bed sides and thus the clearance problem. He also said that they are working on a solution but that it would involve a complete redesign since they are uncomfortable with simply raising...

After I looked at the pin box this morning I don't think that I can cut it down like you described. It has a flange like an angle iron along the bottom heading out and the bolts are pretty close to the back edge. Sure thought that you had the solution until I looked at it this morning. Thanks...

I just bought a Cyclone 3950 and we are now in the learning curve of using it. Right off I experinced a problem while turning a semi tight corner. While I was watching to make sure the cab did not catch the trailer; the back of the pin box got into the rail on the side of my truck bed that is...