120 panel not labeled

We are second owners of a bighorn 2010-3670 rl. The 120 panel has no labels. Can anyone post a pic of one that is labeled.

This is the breaker panel for our 2009 BH3670. The layout may not be the same for your's, however. The photo with the red labels is what I superimposed over the photo of the actual panel next to it. It was labelled, but it doesn't photograph very well.

If the label is blank. Plug into 120V...turn everything on.....then turn off one breaker at a time. See what quits and mark the label. Not all Panels are the same.

Turning off the breakers one at a time may get you stumped. At least one breaker only goes to wall sockets on my rig. Took a few minuets to figure it out. Get a good one. The cheep ones will show a good connection and will have an open ground. Been there done that. You can also plug this into the parks power pedestal to make sure the park power has a good ground. Don't use or plug into a park pedestal if the ground is bad. You can end up with hot skin and get electricuted.

http://www.soscleanroom.com/product...unding-plug/?gclid=CJXH5pHe48sCFQJsfgodJEEJiA

http://www.globalindustrial.com/p/t...mpaignId=T9F&gclid=CNvD267g48sCFVFlfgod_MUO-g

Thanks this gives us a start on look fours. We have been cutting them off and labeling