Reckoning_Man
Member
Furnace Outlet does not line up with floor inlet Ducking.
I have a Suburban SF-35 Furnace, the outlet port on the Furnace is positioned in the middle while the floor inlet is positioned to one side. Resulting in only half of the hole open. Is this a factor defect or should I notch the floor so they align. Trying to make the best decision before applying the gasket etc.
In the photos, you can see that the floor port is over to the left.
I have a Suburban SF-35 Furnace, the outlet port on the Furnace is positioned in the middle while the floor inlet is positioned to one side. Resulting in only half of the hole open. Is this a factor defect or should I notch the floor so they align. Trying to make the best decision before applying the gasket etc.
In the photos, you can see that the floor port is over to the left.