I suppose most of you reading that title thought I had a personal problem..
Just had a quick question regarding the underbelly of the camper. Our 37QB has a black "ribbed" panel that runs the length of the camper underneath. After looking closer at it this weekend there were a couple bolts that sheared off while drilling through the frame enabling it to hang down a bit. Upon pushing it up a bunch of water came out the side which I'm hoping is from the rain that I pulled it home in, and not leaking lines. I can see a reflective mat in there which I'm assuming is an insulating layer of some sort, but there is/was water accumulating in the middle. I have since added a couple screws along the frame but the weight of the wires and hoses inside tend to push down a bit on the underbelly.
I'm looking at adding a piece of aluminum angle iron across the bottom to hold it up a little better, just curious if anyone else has done the same or don't worry about it? Also is there any concern with remaining water under there? I'd rather not drill weep holes but I guess I could.
Any advice is appreciated.
Just had a quick question regarding the underbelly of the camper. Our 37QB has a black "ribbed" panel that runs the length of the camper underneath. After looking closer at it this weekend there were a couple bolts that sheared off while drilling through the frame enabling it to hang down a bit. Upon pushing it up a bunch of water came out the side which I'm hoping is from the rain that I pulled it home in, and not leaking lines. I can see a reflective mat in there which I'm assuming is an insulating layer of some sort, but there is/was water accumulating in the middle. I have since added a couple screws along the frame but the weight of the wires and hoses inside tend to push down a bit on the underbelly.
I'm looking at adding a piece of aluminum angle iron across the bottom to hold it up a little better, just curious if anyone else has done the same or don't worry about it? Also is there any concern with remaining water under there? I'd rather not drill weep holes but I guess I could.
Any advice is appreciated.