We had that problem too I took the shower en closer completely apart and recaulked the whole thing when I REASSEMBLED it.that stooped all the leaks.I made sure that I caulked under all the pieces that were on the bottom and the walls.
I would think that if the TT you are looking at has a tongue weight less then the truck is rated for you would not need them,if it is more then they would be helpful.
Neat looking shotgun.I will stick with my S+W mod 500 with 500 gr hollow point.more hitting power longer range and 2 lbs lighter 10 inches shorter.Only downside is it only holds 5 rds,but if you need more your heart or your head is not in it.
I had the same tilt on ours.I had to pull the top off the bed frame(head of the bed) to see how to adjust it.The adjustment was real easy.However on our ER I had to use a jack on the outside edge of the slide to hold it level while I did the adjustment on the inside.From start to finish it took...
I just checked all of ours and did not find any cracks at all.We full time and our AC is on all the time so the interior stays at a even temp and humidity.So it sounds like a design problem.
I guess I should have looked at the active post before I started a new thread.I changed out the stove light with a LED bulb it is made by Star Light.The part number is Revolution 921-160.the cost was 27.49 I feel it is worth it becuse you can see what you are doing and it should last 60,000 hours.
Findley found a light bulb for the stove light on our Eagle Ridge.After 2 years the one thing that really annoyed us was the stove light it was not worth even Turing on.We found a LED light that is 160 lumen's and just plugs into the socket.now when we hit the switch we can see what is in a...
Over the years seeing what the chemicals at Blue Beacon as well as other truck wash locations do to the finish of my truck I only wash our unit by hand.I use a soft brush and gel cote friendly soap.I also do the rubber roof treatment at the same time twice a year.It may be a little labor intense...
You might want to look at the Viewcube it gets its power off the coax so you don't have to run the dc cords. I have been using mine for almost 4 years now and have not had a problem yet.Just a thought.
Congrats on the new unit.When you go to pick it up plan on at least 4 hr for the pdi a hole day would be better.Make sure that you work everything in the unit.Have the dealer fill all the tanks so you can check for leaks,and make sure the water pump works.Be very picky so that it is all...
We had the same problem in our ER got 2 #4x1/2 inch SS screws driled small hole in the end of the strainer screwed in the screws left about 1/4 of the screw out and no more problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.