Recent content by harleyjeeper

Dealer is unable to fix Lippert Level Up system! Originally I was unable to raise the two rear sets of jacks of the six point Lippert Level Up system on my 2015 Heartland Cyclone 4200. I called Lippert for technical support help. They emailed me a troubleshooting manual; was having freezing rain...

I received an e-mail from MORryde. Short answer is I can not use their door. They said since the door frame in the trailer is not their door frame it's not practical. So evidently it would be a major & expensive project even if an owner & MORryde wanted to attempt it. They would have to cut...

I've read several treads on Lippert Ramp Door failures caused by water infiltration due to the lack of sealing. From those posts when your unit is out of warranty it is obvious that Heartland and Lippert were of little to no help in resolving those failures. My 2015 Cyclone 4200 ramp has become...

I have just found the right rear axle hanger has broken off at the weld just like yours on our 2015 Cyclone 4200 toy hauler! I was checking on the suspension because of a failed front leaf spring. This is the kind of poor production that gets people killed! There should be a recall on these...

The door side lead axle leaf spring on my 2015 4200 Cyclone (triple axle) appears to have flattened, a total failure! All other 5 leaf springs appear arched as you would expect. This unit was purchased new in '15. My selling dealer has since been sold and subsequently gone out of business. I've...

Obvious a common problem from the other replies. We had the same problem in our 2015 Cyclone. Went to a local furniture store and purchased a leather couch (power recliners) & a power recliner chair (back ordered). Hope they last longer that the 4 years we got out of the OEM vinyl crap.

Thanks for the replies! From those and the advice of the service writer instead of buying a direct replacement we went to a local furniture store, with our dimension limitations in hand. We purchased a Violino 3 seat leather couch (power recliners at each end) and matching leather power...

I'm having a similar problem with the material on the five seat couch in our 2015 Cyclone. The two recliners used the most are pealing at the headrest. Also the fold down back between them is pealing in several places. I would have though they would last longer! I know they probably use the...

Unit: 2015 Cyclone 4200. The five seat couch material is wearing off sooner than I would expect. I have attached pictures. Anyone else experience this? Any solutions or advice would be appreciated. Are there any better quality replacement furniture available? Thanks in advance for your time.

Again thanks to all that responded! I ordered 17.5 Lionshead wheels & Continental tires from: http://www.trailertiresandwheels.com/ I picked them up at a local freight company easy deal they loaded the palliated load on my Aluma trike trailer. Here is a pic after I put one on. Then after getting...

Re: Seeking suggestions for Replacing 16" wheels & tires with 17.5" on Cyclone 4200 I called in to get information on the wheel's PSI for the given load rating, it wasn't included on web site info. When completing the order I was given the option of providing a "business...

Re: Seeking suggestions for Replacing 16" wheels & tires with 17.5" on Cyclone 4200 Thank you everyone who responded. I have ordered 17.5 Continental HTL2 ECO Plus 215/75R 17.5 LRJ tires & Lionshead wheels from: http://www.trailertiresandwheels.com Wheels & Tires Mounted...

Thanks to all who have provided input on my question so far. Harold Leeper Panora, IA

Has anyone replaced their 16" wheels & tires on triple axle trailer? What did you go to? Any recommendations would be appreciated. Asking as over the past two years I have had 4 tires go bad on my 2015 Cyclone 4200; one blowout & three had ply separations (air loss). Several tire/wheel &...

It's been quite awhile sence I fixed this. But as I recall under the slide I found several kinks in the line leading to the refrigerator so I replaced that line starting at the T fitting all the way to the refrigerator. solved my problem!