Dealer is unable to fix Lippert Level Up system!
Originally I was unable to raise the two rear sets of jacks of the six point Lippert Level Up system on my 2015 Heartland Cyclone 4200. I called Lippert for technical support help. They emailed me a troubleshooting manual; was having freezing rain...
I received an e-mail from MORryde.
Short answer is I can not use their door.
They said since the door frame in the trailer is not their door frame it's not practical.
So evidently it would be a major & expensive project even if an owner & MORryde wanted to attempt it.
They would have to cut...
I've read several treads on Lippert Ramp Door failures caused by water infiltration due to the lack of sealing.
From those posts when your unit is out of warranty it is obvious that Heartland and Lippert were of little to no help in resolving those failures.
My 2015 Cyclone 4200 ramp has become...
I have just found the right rear axle hanger has broken off at the weld just like yours on our 2015 Cyclone 4200 toy hauler!
I was checking on the suspension because of a failed front leaf spring.
This is the kind of poor production that gets people killed!
There should be a recall on these...
The door side lead axle leaf spring on my 2015 4200 Cyclone (triple axle) appears to have flattened, a total failure!
All other 5 leaf springs appear arched as you would expect.
This unit was purchased new in '15.
My selling dealer has since been sold and subsequently gone out of business.
I've...
Obvious a common problem from the other replies.
We had the same problem in our 2015 Cyclone.
Went to a local furniture store and purchased a leather couch (power recliners) & a power recliner chair (back ordered).
Hope they last longer that the 4 years we got out of the OEM vinyl crap.
Thanks for the replies!
From those and the advice of the service writer instead of buying a direct replacement we went to a local furniture store, with our dimension limitations in hand.
We purchased a Violino 3 seat leather couch (power recliners at each end) and matching leather power...
I'm having a similar problem with the material on the five seat couch in our 2015 Cyclone.
The two recliners used the most are pealing at the headrest.
Also the fold down back between them is pealing in several places.
I would have though they would last longer!
I know they probably use the...
Unit: 2015 Cyclone 4200.
The five seat couch material is wearing off sooner than I would expect.
I have attached pictures.
Anyone else experience this?
Any solutions or advice would be appreciated.
Are there any better quality replacement furniture available?
Thanks in advance for your time.
Again thanks to all that responded!
I ordered 17.5 Lionshead wheels & Continental tires from: http://www.trailertiresandwheels.com/
I picked them up at a local freight company easy deal they loaded the palliated load on my Aluma trike trailer.
Here is a pic after I put one on.
Then after getting...
Re: Seeking suggestions for Replacing 16" wheels & tires with 17.5" on Cyclone 4200
I called in to get information on the wheel's PSI for the given load rating, it wasn't included on web site info.
When completing the order I was given the option of providing a "business...
Re: Seeking suggestions for Replacing 16" wheels & tires with 17.5" on Cyclone 4200
Thank you everyone who responded.
I have ordered 17.5 Continental HTL2 ECO Plus 215/75R 17.5 LRJ tires & Lionshead wheels from:
http://www.trailertiresandwheels.com
Wheels & Tires Mounted...
Has anyone replaced their 16" wheels & tires on triple axle trailer?
What did you go to?
Any recommendations would be appreciated.
Asking as over the past two years I have had 4 tires go bad on my 2015 Cyclone 4200; one blowout & three had ply separations (air loss).
Several tire/wheel &...
It's been quite awhile sence I fixed this. But as I recall under the slide I found several kinks in the line leading to the refrigerator so I replaced that line starting at the T fitting all the way to the refrigerator.
solved my problem!
Thanks so much for creating this guide!
My 2015 Cyclone has just started having this problem.
After returning from a trip I drained the fresh water tank.
The next day i hooked up to our house water putting the Anderson valve on City.
Water starts trickling out of the fresh water drain!
Now I...
RESOLVED-Picked up unit and have used it a couple of times. Legs are well within the standard 3-5 degrees. Shims don't look the best but that's the resolution. The dealer was to provide me something in writing on this issue but has yet to do so! Not holding my breath on that one!
PORTHOLE, thanks, for that info. I have not picked up my unit from the dealer as now I'm in the UK. So, I'm waiting to be filled in on that when I get home. I'd sure like to have that in writing or a copy of the email exchange with the dealer and Lippert/Heartland. If they would have told me...
I went to the dealer today as I needed to get some things out of our trailer for a trip next week, they were closed but I was able to get to the trailer anyway.
I measured the angle of the landing legs and bracket using "lemondo bubble level" app on my phone. To my surprise both legs measured 3...
Thanks for all your comments.
Dealer already sent picks & measurements to Lippert.
The result was no action on Lippert's part
Dealer is now "working" with Heartland, no decision as of yet.
Trailer is still at dealers.
I will see if I can get to it & determine if the angle is greater than 5...
I see what you are saying I'm sure that was cause by the shadows in the photo here are individual pics of the landing gear.
I'm pretty sure they are the same but trailer is still at dealer so I can't check right now.
Thanks for the input.
We have a 2015 Cyclone 4200 with the Level Up hydraulic leveling system.
The left front landing leg is angled out (see pic).
This is condition is certainly more noticeable when fully extended.
There is no obvious frame bending or bracket distortion.
I believe the mounting bracket was welded at...
WOW, that is dangerous! What did your dealer have to say about that? As with several other issues I noticed that your bracket is different than the one in our 2015 4200. Would add a picture but our unit is at the dealer for a couple other problems.
The LG in my 2015 4200 does not have a water dispenser, just the ice maker. I was not clear I opened the valve under the sink and then opened the T under the slide to bleed the water to that point. I have cycled the ice maker several times to bleed the water to that point as I have frozen water...
I have same problem with the domestic LG in our 2015 4200. Yes, we are plugged into 110V at home & parks. We opened the valve under the sink for the ice maker line and have opened/bled the drain tee under the slide out. We now have water drops (frozen) in the ice bin but no ice. The ice make...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.