Recent content by im_1406

We area hauling 1 bagger and 1 sporty.....and we are VERY happy with the B&W Biker Bar solution that eliminates strapping the bikes. Been across the country without straps and never a flaw.

Thanks Porthole.....my post was post was the final update with photos (done). Your suggestion was spot on though....there was trim easy to remove to access the wiring.

Easy access to side channel wiring to add more lights. Easy mod!

You are correct - it is generally the single drain you have identified. Open and let flow......

I've worked with that type of kit before for other applications. When you applied the lights to the roller did you recess in the channel or just apply on top of the barrel? Also, where did you hide the receiver box? Photo? thank you!!

I think you are into something. The recessed channel they sit in on the awning roll holds water it seems....promoting seepage.

Anyone else experience their Carefree Awning light going out in various places? Looks like there is I moisture getting in and shorting them out. Both of my awnings look the same. I don't want to repurchase with the same......in fear it will just do it again. Thoughts? - - - Updated - - -...

Last update: We are back in business. Interesting note....the photo below shows the replacement room bar. Notice it is Chanel Iron.... The original build was the same except Lippert cut the channel down the middle, essentially causing it to be weak and without integrity. With as often as we...

1 month update: Sad to say, I am Amazingly frustrated with Lippert. They were to ship our "room bar" August 17th (the date came and went). Then with multiple excuses and apologies, they said it would ship August 24 and to make up for complications on their end, they would express ship it...

Thanks for the phone numbers and suggestions. The room bar is made by Lippert. Unfortunately the slide is not functional as the room bar is pulling away from the flooring of the slide. Very upsetting.

Dear Heartland, I have just been informed by my local rv shop, my room bar on our Cyclone 4200 2015 needs to be replaced and will take 3-4 weeks to receive the part. This is located on the large slide. I'm writing in hopes, through this forum, there is an opportunity to have the part shipped...

It's been dim for months so I finally decided to post the question. After a 3 hour ride home today, it mysteriously turns on full brightness! Must be a loose connection. Will have to drop it and investigate. Too funny.

Just started....

Good ideas! I will try them out.....it is a switched light, but all the others on it are fine.

I have one dim led light in the master bed....what can I check? All other lights throughout coach are fine. Doesn't matter if on battery or shore power.