Recent content by RoadJunkie

See if it works on propane.

The factory stems are too small for the higher pressure wheels, same on my GMC. Mine do not read pressures higher than 100 psi, as well. Amazon has some TPMS sensors that work.

Heartland markets that connector as a "solar interface" where you can directly plug in a solar panel charging system. I use the battery disconnect and then attach a trickle charger to the inlet.

Have you checked your regulator with a gauge, or just relying on the setting to determine 50psi?

Because something is done in a particular manner, doesn't mean it always has to be done in the same manner. Nice job.

I unscrew the anode rod and let it drain. If you want faster results, lift up on the lever for the overpressure valve to allow a vent source.

Routemaster, you are on the right track. After removing the facia, you must remove all the screws that attach the slide out ceiling to the header. Once that is done, lift the roof and then reattach the header to the new, higher, position. Some have reversed the "crown" of the header to reduce...

Research the web for your refrigerator's manual. The answers you're looking for will likely be there.

On my 2017 Bighorn the slide has a rubber, EDPM, material.

Cody Hockenberry <Cody.Hockenberry@heartlandrvs.com> You Good Morning, I have just herd back from our engineering depart on a repair solution for your sagging roof. I will copy and paste their response in yellow. I hope this information helps aid you in your repair. Remove top facia and...

In my case, I didn't worry about removing the "V" dip out of the facia, I only wanted to raise the ceiling to avoid the dip. My 2017 looked a lot like yours as far as the facia. By the way, I know of several people that have had to perform this process. I would consider flipping the header to...

Google operating temperatures of Lithium batteries, also battery heat pads.

Prace: Your concept is sound, however it is not necessary to permanently attach the pole. Behind the facia is a header and the ceiling needs to be reset along with the header. If one removes the facia and the screws that attach the header, a lift mechanism, similar to your pole, can move the...

Now we need a picture of your seals on that side of the slide, top, middle and bottom.

The heat losses from cracks in slide openings, single pane windows, plastic vent covers, etc, are huge. If you are stationary, you can add insulated skirting, which is a big help. You can put aluminum bubble insulation on the windows, but that really makes it feel cave-like. Keep the air...