avvidclif
Well-known member
I filled the fresh water tank with 90gal of water for a dry camp trip. Since I have been weight limited (old TV) I haven't done this before. All was well. When I raised the front this AM to hook up I had water running out from the rear of the coroplast. Evidently I put in too much BUT the overflow line is not extending thru the coroplast. Any ideas where is should be located so I don't have to remove a bunch.
Also while under it I noticed a row of self-tapping screws going down the middle of the coroplast (front to rear) that had poked holes in it. It appears at one point there had been a support something that extended from the front to the rear of the coroplast and they held it up. These screws came down from the top and the ends were sticking out thru the coroplast. Wonder how they did that??
Anyway any ideas on supporting the coroplast and finding where the drain line should be??
I'm thinking of pieces of 1x2 wood blocks abt 2-3" long screwed onto the end of the screws. I have abt 3/4-1" sticking out with 1/2" of thread showing. At least for the trip tomorrow and something else run front to back later.
Also while under it I noticed a row of self-tapping screws going down the middle of the coroplast (front to rear) that had poked holes in it. It appears at one point there had been a support something that extended from the front to the rear of the coroplast and they held it up. These screws came down from the top and the ends were sticking out thru the coroplast. Wonder how they did that??
Anyway any ideas on supporting the coroplast and finding where the drain line should be??
I'm thinking of pieces of 1x2 wood blocks abt 2-3" long screwed onto the end of the screws. I have abt 3/4-1" sticking out with 1/2" of thread showing. At least for the trip tomorrow and something else run front to back later.