ILH
Well-known member
I'm looking for advice on modifying my bunk beds so that the top bunk bed descends and stops at a lower height than the factory presets.
I noticed that there are 'stops' screwed into the tracks. One option might be to lower the stops to the new height. However, I was thinking that a simpler solution might be to remove the stops altogether, then drilling new holes for the pins that are normally used to hold the top bunk in the upper position. The new pin holes would be at the desired bunk height.
Would that work?
I noticed that there are 'stops' screwed into the tracks. One option might be to lower the stops to the new height. However, I was thinking that a simpler solution might be to remove the stops altogether, then drilling new holes for the pins that are normally used to hold the top bunk in the upper position. The new pin holes would be at the desired bunk height.
Would that work?