Recent content by Curt_Hinson

  1. Curt_Hinson

    GFCI circuit.

    If I plug the refrigerator into its original plug, the GFCI circuit will pop. If I unplug the refrigerator, the GFCI plug and the secondary plug plus the dishwasher will work. It may work for one hour or one week. If I plug the refrigerator into a Short cable GFCI or if I simply plug the...
  2. Curt_Hinson

    GFCI circuit.

    After at least 5 times in the repair shop, my GFCI plug built into the bottom of my cabinets over the kitchen sink works if I remove my refrigerator and run it separately with an outside cord. Long story short, the repair shops all said that the circuit was fixed and everything operational. One...
  3. Curt_Hinson

    LCI Hydraulic 6-point Leveling System Control Panel

    Thanks to everyone who responded to my post. I will try to describe everything I have done so far. 1. I had 1 battery in the system.I had purchased two batteries with the intent of using both, but got side tracked and never put the 2nd one in. I removed the one battery and fully charged it...
  4. Curt_Hinson

    LCI Hydraulic 6-point Leveling System Control Panel

    Thanks for the info, but I have about 5 brand new ones I purchased at an auto parts store. Every connection has been checked and re-checked. I will run thru all of them again. If it doesn't work after that, I will buy more new ones.
  5. Curt_Hinson

    LCI Hydraulic 6-point Leveling System Control Panel

    Thanks to everyone for responding. I apologize for the lateness of this reply, but have been working at many activities in preparation for a trip to Texas. Since my first post, this is what I have done to the camper regarding possible low battery voltage. I charged two deep cycle batteries and...
  6. Curt_Hinson

    LCI Hydraulic 6-point Leveling System Control Panel

    I called LCI regarding a switch beside the Automatic Hydraulic 6-Point Leveling System control panel on my 2014 Landmark Sequoia. The switch is installed with two square head screws. The control panel box appears to be manufactured by LCI, but the gentleman I talked to did not have a clue. If...
  7. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Dan, water leaking behind the dishwasher could be a problem but no running water or wetness has been sighted where we can see. I will say that I don't think the dishwasher has been operated more that two times since I have owned the unit. I have had this problem for some time now so we have had...
  8. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Dan, I can't get my pictures uploaded, but the two links below show my layout. The youtube video is for a 2013, but it is basically the same unit. I requested and received a build sheet for my unit from Landmark. Is it the right one, I don't know. If you want to take a look at it, I will send it...
  9. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Dan, you need pictures. My wife stated that there was a dent in the floor in the kitchen area and that she believes that there was an island, but one does not exist in my RV nor does any floor plan I have seen show one.
  10. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Hi Dan. I am sorry that I am not making myself clear on this. I will take pictures tomorrow. 1. The GFCI is the first in line from the circuit breaker at the bottom of the cabinet and is located above the kitchen sink and under the overhead cabinet. 2. To clarify one point. The refridgerator...
  11. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Roller4tan, non of that applies to my situation. I remove the outside breathing cover of the refer where all of the gas and electrical components are, reach in with my right hand going back about 12 inches and unplug the refer. I plug it in to the short extension (GFCI plug in a box with about...
  12. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Jim, it may well be that everyone but mine is wired as you say, but I can tell you that if I get the GFCI working under the counter, I can start the dishwasher and get the refridgerator to run on electric. If I have the refer set on automatic, it will automatically come on but if that circuit...
  13. Curt_Hinson

    GFCI circuit not working in kitchen, dish washer and refridgerator

    Sorry, I initially posted this in blog. I have a 2014 Landmark Sequoia. Under the top cabinets, I have two 110V outlets. I believe the problem started when my wife, many moons ago, plugged the coffee pot and toaster into the outlet nearest the window. The outlet on the right (first outlet from...
  14. Curt_Hinson

    Slides having trouble coming in and going out

    Sorry, but I stupidly posted this in BLOGS. 2014 Landmark Sequoia. I recently started having trouble with my two main slides in that they will come in part way and stop. Sometimes I can reverse them and they will begin to move out (or in as the case may be). Most of the times, they will come in...
  15. Curt_Hinson

    Comfort Control Center 2 Thermostat not working

    Thanks to all respondees. Dan I had forgotten about the 12V fuses. For things of this nature, I like to use my little auto 12V test light. I couldn't find a ground to hook the alligator clip to, so I opened the front cabinet to see if I could find one there. Too my surprise, the floor of the...
Top