Recent content by david-steph2018

To check the converter is charging, find the power leads from the converter. Using a multimeter, read the voltage across the wires to see what this voltage. In case it is not working, on the outside of the converter should be some fuses. Check these to make sure they are okay. Before you remove...

Here is a copy of the wiring diagram for residential fridge with a transfer switch. https://manuals.heartlandowners.org/manuals/Electrical/Residential%20Refrigerator%20Electrical/Residential%20Refrigerator%20Electrical%20Block%20Diagram.pdf Here is a source for a new transfer switch if needed...

Glad it helped.

No, it is not "just a display". You can use this to manual level the rig. You can use it to retract/extend front or rear legs or each side (right or left). For example, if you have a flat tire, you can use this panel to rise that side to change the tire. Also, if a leg does not fully retract...

Do you have a Lippert Level-Up leveling system installed? It looks like the control panel for that system. Push the small button to turn on, and see what the screen looks like.

The cold-water inlet I referred to, was the inlet on the bottom of the water heater. It is made of plastic, so have it checked to see if the same issue.

Was that 12.9 with shore power hooked in? I would say a battery issue.

Our stairs are on the driver's side. The water heater on the passenger's side. The cold-water inlet had cracked, and the water ran across to settle at the foot of the stairs. This caused an issue and we had to have the floor replaced in that area.

On our 2018 Road Warrior, the freshwater tank vent is between the axles, coming off the top of the tank.

Information: https://lci-support-doc.s3.amazonaws.com/manuals/beds/ccd-0001575.pdf

Our bed did this once. On the rear ceiling in the corner is a control box. Check and make sure the connections are in place tight. One of the wires had come out, just a little, but enough to keep it from working. Also, you may want to check the 12VDC fuse. If none of this helps, you will need...

Our rig is a 45-ft. toy hauler, that we tow with a Ram 3500 dually. I would get what is comfortable to drive & to live in.

What does the back of the switch look like? What kind of wiring is there on the switch?

No way to know if it is factory installed or by a previous owner. So, a question, did a previous owner install an inverter for outlets?

A GFCI should be around a water source. So, start in the main bathroom, check around the kitchen area, outside compartments, any outside outlets. If all of these are okay, you will need to find a junction box and start checking connections. A good place to look may be under a slide-out near the...