Recent content by pjberny5

  1. P

    Any recommendations for EPDM roof separation.

    Sent email below. along with pics to heartland. below is their response. Gary: Have a 3 year old 3260 Heartland Bighorn and in the last few months have noticed the Aluminum warp on the roof that runs the length of the trailer is separating from the underlaying luan board thus lifting the...
  2. P

    Any recommendations for EPDM roof separation.

    Pics 3 and 4 is a separation of the under lying lapboard between the first 2 boards starting at the front cap underneath the rubber roof
  3. P

    Any recommendations for EPDM roof separation.

    Have a 3 year old 3260 Heartland Bighorn and in the last few months have noticed the Aluminium warp on the roof that runs the length of the trailer appears to be separating thus lifting the rubber roof. Also appear to have a 1/2 to 3/4 inch separation between the first sheet of ply-board...
  4. P

    Slideout and leveling system breakers

    Phil. I'm still trying to figure out which breaker or breakers to replace. Is there one each for the slides and another for the leveling system. I have a bank of 6 breakers one of which appears to have a small black re-set button which the other 5 do not have.
  5. P

    Slideout and leveling system breakers

    Thanks Dave. Found a wire with a piece of red tapet on it where it connects to the breaker. That particular breaker has a tiny little what appears to be a re-set button only breakers I could find were without and were auto re-set breakers.My issue is that both the slides and landing legs...
  6. P

    Slideout and leveling system breakers

    Can anyone tell me which breakers go to the slides and which on goes to the leveling system. 2014 -3260EL Bighorn. Attached picture front my breakers.
  7. P

    Front Landing Jacks Safety switch

    Sorry. Have the Bighorn 3260EL with Hydraulic Landing gears.
  8. P

    Front Landing Jacks Safety switch

    Little concerned that the switch to the front leveling jacks is located where anyone can push it. Is there a switch any where that will prevent/disable the the front landing jack switch with out affecting any other trailer electrical components. .
  9. P

    Bighorn 3260EL Shocks

    Thanks. YOU HAVE BEEN MOST HELPFULL
  10. P

    Bighorn 3260EL Shocks

    Curious what you mean by. Remember, you'll need another or longer length bushing for the top of the shock because of the extra shaft length on the Bilstein shocks. (double up on the bushings) Can additional or longer bushings be purchased separately.
  11. P

    Bighorn 3260EL Shocks

    Rex: If decided to go with the Bilsteins and was wondering on your technique to compress the upper stem. Thanks in advance. Paul.
  12. P

    Bighorn 3260EL Shocks

    Thanks for the ebay link. A lot cheaper than on shockwarehouse.com which lists them for 83$.
  13. P

    Bighorn 3260EL Shocks

    Rex. First thanks for the response. Would this be them. This is from shockwarehouse.com - 24-064194 F4-BE3-6419-M0 Bilstein Dexter Trailer Axle Old Part No: F4-BE3-6419-M0 Also called the Bilstein B6 Series or Bilstein 4600 Series, the Heavy Duty has an...
  14. P

    Bighorn 3260EL Shocks

    Have less than 20000 miles on my 2014 3260 Bighorn and noticed two of the shocks are leaking oil. Any recommendations on a replacement shock and are they difficult to replace. I'm pretty handy at fixing a lot of things. I'm an old farm boy. I assume you will need to replace them all.
  15. P

    Do I Need New Wheels with Tire Upgrade?

    Replaced all my Towmax tires including the spare for the Sailuns on my 3260. Kept the same rims and just finished a 12000 mile 4 month trip thru the Dakotas and the northwest. Set the PSI at 100lbs. FYI. No issues. I do check the pressure and lug torque before each move. 3 of the towmax had...
Top