Recent content by twilliams

Agreed!! Thx! Sent from my iPhone using Tapatalk

Dan, once again, you are amazing! I unplugged the converter and plugged it back in, which worked! cant thank you enough!, Tony

Yes. Plugged and and all 110 appliances are working. No blown fuses or tripped breakers.

I have a 2015 LM365, Ashland. When we got up this morning I noticed that the D.C. Powered lighting was dim. A few hours later nothing. I replaced both batteries three months ago. Any suggestions on troubleshooting this?

I cant thank everyone enough for the help! I got the wires back on the new batteries safely. I went through the suggestions Given and found a loose outlet the converter was plugged into. So, after fixing that we are back in business! this forum is a big help. Thanks to all the regulars that...

The batteries are dead. Sent from my iPhone using Tapatalk

I don’t think so. I have a big screen over the exhaust. It has been there for over two years. Sent from my iPhone using Tapatalk

So on a second look there are 2 red wires, two black wires, and a white wire. See picture. The two reds should go to the red Post and the two black wires and the white wire should go to the black Post, right?

Here are a couple of pictures, the posts and the wires. - - - Updated - - - So-one red cable to the red Post. Two black cables and a white cable to the black Post?

So- the batteries are two-three years old. Original equipment. Think I will replace them. I know this sounds stupid, but not sure exactly which wires go where when I hook the battery box back up. I did not mark the wires before disconnecting them......... There is a red, white, and two...

Woke up this morning to a cold RV. Went out and changed the propane tank. The heater came on and heated everything up nicely for about 30 minutes. The smoke detector went off and then a few minutes later the heater stopped working. There is no noticeable smoke or fire anywhere. The battery...

Great idea! Thanks for that. - - - Updated - - - Thanks for the advice! - - - Updated - - - Thanks so much for thee advice and information. VERY HELPFUL!

Makes good sense. So- the next step is to isolate the device that is humming, likely the transfer switch or the converter. Once I know which one it is I will need to determine what action to take. From other posts I have read I see that I should make sure all the wires are tightened down and...

So- is there any immediate danger with this situation I should be aware of?

I am hearing a humming sound in my landmark 365, 2015 Ashland. After reading a couple of other threads I opened the door to the basement and it seems to be behind the wall there. Is this where the transfer switch is! Could it be that or something else? What should I do to fix it? The humming...