Search results

I think my front cap is about to hatch a chick or something, cracks radiating out !! job to take pictures cause of the shine anyone had this problem with cracks whats the best fix also on the rear cap some either side. Yet another thing to add to the list.

Not finding the thread about this problem already started. I have removed the fascia and have worked out how to lift the ceiling which needs a lift of 3/4", wipe out, and does not even touch the outside rubber roof what a mess, but I am not sure about the procedure. A 3/4" concave bow going the...

Does anyone know where I might buy a topper roller tube used or new, because that mine dining slide tube is 5" too short and does not cover the roof? Den.

Do any of you have good ideas on how to make the crooked bed pop out, retain heat, and stop it from being sooo cold for the pillows? I have thought about as seen on U-tube where a person wrapped Styrofoam sides top and bottom, a bit cheesy though for a $160,000.00 rig and 365?? Den.

Would anybody be running their Splendide washer not washer/dryer on an inverter if so which one I know an LG we had in the other coach on the Magnum Pure Sine Wave lost the motherboards twice in the LG machine? Den.

I think these Inline P Traps are out of the UK and AU had to clean ours out, there is a rubber tube in that top part that fits... I think between the O seal flange trapped by the top nut when done up and this one is manky anyone seen where to find the inside part? I put it back together and so...

My Mini Split draws 10amps on the 110v well (worth the investment by the way) what would I require to run it off the solar? I have a Magnum 2000 with four (4) 6v deep cycle batteries flooded looking to upgrade soon. Den.

Will the TriStar TS-MPPT-60 handle lithium batteries if so what to do? I need to change out my flooded ones?

Well, I decided to install a mini-split after seeing what S Branch did to his toy hauler. I bought a Pioneer WTY-22, and today was the first time of using the unit early days yet got to get used to the controls. The thing does blow out cold air. The only place I felt that I could put the head...

Are there two layers of wood with air space between them throughout the coach? I drilled a small hole down at the outside of the "I" beam at the outriggers. I felt space after drilling through the main floor and then through some wood where the waterproof is stuck on underneath. Is this common? Den.

Does anyone know where I could buy this as in the picture hide a cable? I have searched with no joy what I have found is overseas.

I have a new Dometic awning switch to go in but there are six spades on the old one compared to four on the new one any ideas on this situation about different colour-coded wires?

I have an R.O. style tap I wish to install at the kitchen sink anyone done this? good location on the counter top also would one need a carbide drill bit and do you need a puddle of water on the surface to stop fracture? I was looking to pass the 1/4" pipe through the belly from the front...

Did any member install the LCI Solid steps in your 5er, did you feel the need to go with bolting the plate under the floor or just using the wood screws?

My Surge Guard has developed a loud-ish hummmm is it time to retire her or is there something that can be done? ear plugs help at nite.

On Sunday at this RV part around noon, we had a power outage wife had the washer running so I switched on the onboard generator for close to an hour then the power came back, and off goes gen. Now 5:30 am Monday a bang was heard I found out that was the washer along with a smell. Not only that...

Has anyone here repaired the inside cracked-up skin on the door? I have not found a replacement part on the Lippert inter-web.

This morning after the heating was running for a couple of hours the motor changed tone along with the lights dipping any thoughts? Den.

Is there any reason why one can't add a transfer switch so as to have a third way to supply solar power to the coach by moving the gen wire to the new box with the solar input and then out of the new box to the input gen of the exiting box? Den.

If you were adding a curtain rod, would you first attach a length of matching stain wood over the top of the door frame door so as to hit studs then fix the rod brackets to the wood, or use the dry screw wall anchors supplied? I am not so sure about the latter. Thanks. Den.

I have some dead LEDs lights in our bedroom neckless do I just remove the screws and lower the woodwork to get to the led strip? Den.

Is this right, should they not be in the center of the pockets? there are gaps around the tops of the rubber surrounds of lights.

Something else. Anyone has eggshell cracks in the front cap if so, what did you do about it? Den.

Where might the entrance door light switch be located not seeing anything around the frame? Last night the dome light came on and off all on its own during the rainstorm, eerie!! Thanks. Den.

Does anyone have their Atwood oven that takes more than 30 mins to reach a temperature of 350* and the dial is out 25* I needed 425* for my GF muffins? I have looked at the paperwork on site here and nothing on how to fix this problem. Den.

Hey, the washing machine filling up and starving the loo of water anything one can do?

I am not finding the part number here for the SW12DE water heater to replace the board.

Anyone recommend a good Corian cleaner/polish to be used on the counter tops?

Those of you that may install a pressure tank that goes in after the pump, thoughts on the 5gallon that has the pump mount on the top do you think that setup would cause more vibration? I see it online for $40.00. This also could be a snug fit.

I have a new Lend -A -Hand Extended Assist Rail. Not too sure about the third screw supplied, should there be enough material in the stud to pre-drill at the location for the screw, has any done this mod? Den

I am not getting any cold air out of all the vents 9 curbside where do you think I can look? 72* out of roadside and 92*curbside.

Who sells the 12v black switches in the main panel with the tiny red led light in them, I am not finding them in my searches?

Did Heartland stop welding Correct Track on the model year 2017?

Do we have a recall on propane gas fittings?

Anyone has this issue and what was the fix?

Oops! It appears that Javascript has been disabled in your browser, and this application’s great experience relies on Javascript to function properly. Oops! It appears that Javascript has been disabled in your browser, and this application’s...

Has anyone had the door leak water running in around the window frame, I would guess disassemble and reseal?

Did anyone install Bulldog front landing legs?

Any had dealings with the B&B leaking?

Anyone have a step by step to change out this tank does one have to lift the tank up and out as it appears to have the straps on the bottom. ? I now believe that I have a leak.