That is how this one is set up, so says the booklet....all 3 ACs can run until a user defined heavy load is applied (electric heater, microwave, hair dryer, etc) The PCS will sense that, then shut down an AC until user's load is shut off, then will pick up that AC again automatically.Thanks for providing the pics, I hope the upgrade is available where all 3 AC's can run on shore power without worrying about tripping the breakers.
If it is a 120V flip up/down toggle switch, we have one too that is unknown what it does yet as well....It doesn't do what we were told during our walk thru.LBR i have a 2017 4113 with this same setup my breaker box ix a exact match and the digital monitor is on the side of the fire place but there is also a orange switch that when down is off and when on is lit up orange. Is this related? i tried asking the tech when i picked up the unit but he didn't know. I want to know if its ok to run all 3 a/c when on 50amp shore power any insite would be greatly appreciated. I tried a search but this was as close as a thread as i could find that was related.
If it is a 120V flip up/down toggle switch, we have one too that is unknown what it does yet as well....It doesn't do what we were told during our walk thru.
Excellent info...thanx for the reply back with the answer!Talk to a tech at heartland that's the tank heaters that are 120V the other switch marked yeti is the 12v water line heaters
Thanks for providing the pics, I hope the upgrade is available where all 3 AC's can run on shore power without worrying about tripping the breakers.
Thanks for providing the pics, I hope the upgrade is available where all 3 AC's can run on shore power without worrying about tripping the breakers.
Here is a pic of our breaker panel and PCS..a later 2017 Cyclone build...hope it helps.
My apologies for the interruption, but I have a quick question. Our new cyclone 3513 came with this display in our control center. But it doesn't power up or do anything. Is it supposed to be connected to something? Service group at the dealership doesn't know. Go figure.
It is a monitor that shows amp draws, service amps available, and air conditioner load sheds. I've had my panel it's mounted in off 5-6 times working on the backside wiring, but couldn't tell you for sure if it is hooked up with a wire harness or separate wires to pins as I wasn't paying attention to that particular item. It may have a wire unpluged or the harness was never plugged it....may be an easy fix if you went investigationg!Nothing at all. Shore or genny or battery. If you don't mind my asking, what is it? Power monitor or controller in some way?
Sent from my iPhone using Tapatalk
Nothing at all. Shore or genny or battery. If you don't mind my asking, what is it? Power monitor or controller in some way?
Sent from my iPhone using Tapatalk