RESOLVED: Furnace runs for a while then goes into shutdown
I'm going to call Dometic tomorrow, but thought I'd throw this on the board to see if anyone has had a similar issue. This started this spring right at the end of the heating season, so we didn't do anything about it. Sadly, it didn't magically fix itself over the summer, so here we are.
Turn on furnace, fan runs, flame starts, heats the trailer as expected. Eventually, before the trailer gets up to temperature, you'll hear a click in the air conditioner (commanding the furnace to shutdown). The furnace will go through a cool-down cycle, shut off and will refuse to restart until you drop 12V power (or wait a long enough period of time).
We mentioned it to the two techs that were running around at the Urbanna rally and they suggested a bad limit switch (not the sail switch).
Anyone else had a similar issue?
I'm going to call Dometic tomorrow, but thought I'd throw this on the board to see if anyone has had a similar issue. This started this spring right at the end of the heating season, so we didn't do anything about it. Sadly, it didn't magically fix itself over the summer, so here we are.
Turn on furnace, fan runs, flame starts, heats the trailer as expected. Eventually, before the trailer gets up to temperature, you'll hear a click in the air conditioner (commanding the furnace to shutdown). The furnace will go through a cool-down cycle, shut off and will refuse to restart until you drop 12V power (or wait a long enough period of time).
We mentioned it to the two techs that were running around at the Urbanna rally and they suggested a bad limit switch (not the sail switch).
Anyone else had a similar issue?
Last edited: