oscar
Well-known member
So I attempted to get a grease gun on the grease points of the running gear, but the designers cleverly located them so that was impossible. Yes, I have a flex hose on my grease gun. Has anyone found an elegant solution to this? Of the few that I could get on, some weren't taking any grease. (little ball probably stuck, but I can't see it)
Something in me wants to block the unit and take all this apart, clean it up and make sure all the wet bolts are indeed wet and functioning properly.
Then again, if I go that far, I may as well put Some Moryde pieces in there.
Which brings me to the next question..... SRE4000 or CRE3000 ?
How will this affect the alleged Dexter self aligning system?
Something in me wants to block the unit and take all this apart, clean it up and make sure all the wet bolts are indeed wet and functioning properly.
Then again, if I go that far, I may as well put Some Moryde pieces in there.
Which brings me to the next question..... SRE4000 or CRE3000 ?
How will this affect the alleged Dexter self aligning system?
Last edited by a moderator:
