beasleyrl
Well-known member
My Cyclone 4250 has 3 AC'a that were installed at the factory. Great concept, but unlike the Landmark with 3 AC's, there is no power management system other than a toggle switch that only allows you to run either the front or middle AC at 1 time (plus the rear). In looking at my breaker box, it appears the unit is also wired for 20 amps for the washer/dryer. Given the configuration of where that washer/dryer would be, I don't ever see us installing one. Would it be possible to run the 3 AC's on 50 amps if we just wired the 3rd AC into that breaker meant for the washer/dryer? I'm attaching a pic of the breaker panel for those that know more about this than me.
One follow up question. When on generator, I appear to only be able to run 1 AC at a time. Is it possible that both AC's as currently configured are running off the same 110 leg? In my prior Cyclone, I was able to run 2 AC's on the same size gen.
Thanks in advance for any wisdom you can provide!
Roger
One follow up question. When on generator, I appear to only be able to run 1 AC at a time. Is it possible that both AC's as currently configured are running off the same 110 leg? In my prior Cyclone, I was able to run 2 AC's on the same size gen.
Thanks in advance for any wisdom you can provide!
Roger