Recent content by wingfoot

Reading all of this adds support to my buying Goodyear tires...I have had two failures on Goodyear's and Goodyear stepped up immediately. I sent pictures of the damage and the failed tire ($3,500 in one case) and within a couple of weeks I had a new tire and a check for the trailer repairs...

Thanks guys, I checked the "plug in's for all systems in the entertainment center, all OK. There was no loss of power to anything else in the trailer, microwave, RAC. I have a voltage meter in the trailer..all seemed well. I think that would eliminate the thought of loosing one leg and if I...

The other morning we woke up to find we have no power to the TV, DVD or anything else (120V) in the rear (3400RE) entertainment systems..The 12V cabinet lights all worked. This outage was only with the TV, DVD, and all things in the rear wall where our TV and all other things (120V) I...

Don't think so Dan...that one does not have a slot in the socket that I can tell. Take a look at John's post...Looks like I may have been looking for the wrong crank. Thanks for the response anyway. Larry

BINGO JOHN....that will work for me! I have been trying to find slotted socket crank that will fit over the rear scissor jacks with a pin in it. Never thought ablout a crank sans slotted socket...I'll start looking for one you describe...I'm not to optimistic though....I've goggled Cranks...

I have exhausted all efforts to find a replacement crank for the rear electric scissor jacks on my 2008 Bighorn. You would think that Heartland would make the Landing Jacks and the rear stabilizer scissor jacks take the same crank, but the female end on the rear jacks is smaller. I've tried...

Unfortunately, Samsung has had it's problems with their power boards. It seems to be a common problem. Google "my samsung turns off or my samsung won't turn off". You should see numerous post and what prople are doing about the problem..Good luck.. BTW, I never got mine fixed...when it won't...

Thanks guys for the tips... Larry

Thanks to all...good information.

Planning a trip from Memphis, TN to the North Carolina line, via I40. Any suggestions on campgrounds along the way? We won't mind traveling about twenty or thirty miles off I40. Our destination is about 550 miles up I40 and we like the 250 mile 2:00 rule for traveling. Thanks for any...

Thanks guys...found the manual and I'll follow the instructions.

Re: Gap on slide seal..big! Problem solved..On site service call. Tech. adjusted slide for proper seating done deal..cost $80.00. All is good!

We are experiencing a strong sulfur smell from our hot water. The smell dissipates if we let it run for about thirty seconds. We are not experiencing an odor from the cold water side. We have a filter incorporated in our shore water feed. At the beginning of this season I drained and...

Re: Gap on slide seal..big! OK guys...sounds like my problem isNOT a piston adj. solution..We are currently camping and I think I'll wait until I get home where I can get some help... Thanks to all for helping me with this problem. I will post later as to my outcome. Thanks again to all.

Re: Gap on slide seal..big! Now what?...I have studied the lippert instructions (thanks Jim) and it looks like I need to either "synchronize" or adjust the the "piston" per their instructions but I don't know which procedure. Since it appears to seal on all sides with a gap at the top right...