AlecnDiana
Member
The slide-out on our Edge is not centered in the wall opening.
The gap on one side is about 1"; on the other it's closer to 4".
The slide-out works fine but the rubber flap seal on the thin side will not flip in or out as the slide-out moves.
I notice that the steel posts holding up the rack & pinion set-up can be moved a little to the left or right.
Is there any reason why I can't loosen the mount screws in the floor and shift the slide-out a bit to center it?
The gap on one side is about 1"; on the other it's closer to 4".
The slide-out works fine but the rubber flap seal on the thin side will not flip in or out as the slide-out moves.
I notice that the steel posts holding up the rack & pinion set-up can be moved a little to the left or right.
Is there any reason why I can't loosen the mount screws in the floor and shift the slide-out a bit to center it?