We just bought a brand PI 322 and took it out for the first time this weekend. It fits our family great, but I was noticing a few issues (which a lot of folks said we would in the first year). One of the I wasn't sure about - sponginess on the rear outside wall.
I noticed this when I was hooking up the 50A power in the back, I put my hand up against the wall and the fiberglass bowed in about 1/2" until it hit solid structure. Then I tried all over the back and it seems like the sheeting is not attached anywhere except along the edges, window and power outlet.
Then I checked all the walls and found the front and back walls on the slide were similar, as well as the sheeting the goes around the fifth wheel hitch and forward compartment.
I'm looking to see if this is something to be concerned about and what would be done to fix it. I'd like to be knowledgeable before I take it back to the dealer, so that I know they will fix it properly.
Sent from my iPhone using Tapatalk
I noticed this when I was hooking up the 50A power in the back, I put my hand up against the wall and the fiberglass bowed in about 1/2" until it hit solid structure. Then I tried all over the back and it seems like the sheeting is not attached anywhere except along the edges, window and power outlet.
Then I checked all the walls and found the front and back walls on the slide were similar, as well as the sheeting the goes around the fifth wheel hitch and forward compartment.
I'm looking to see if this is something to be concerned about and what would be done to fix it. I'd like to be knowledgeable before I take it back to the dealer, so that I know they will fix it properly.
Sent from my iPhone using Tapatalk