Recent content by circusbear

I really like the duct work enclosure as ours is the same way yours was and is always prone to damage. I think I may need to find this product also.

Hey there, What kind of hitch do you have? My Reese slider used to do this. I switched to a Curt and the problem is gone. Kinda scrares you on startup huh??

SJS, Yes I ordered the same kit you did. My plan- if possible- is to mount the light strip on the actual awning tube, then run the wiring down the awning arm to the trailer. This is where I am unsure- follow the awning motor wiring into the trailer and fish it into the basement and hook...

SJS- thanks for the reply...I am torn whether to mount them as you did..or.. mount them on the awning roller. I was thinking your way originally, but then saw the OP and liked the way the light reflected onto the trailer. Was there any way you could have run the cord inside the trailer (ie...

Can somebody grab some pictures of how the wiring is routed and how it hooks up to the power souce. I am very interested in this mod and have already ordered the lights and controller. I think both ways of mounting the lights have pros and cons but am leaning towards mounting the lights on the...

Thanks for sharing. There are a great deal of us that have some sort of damage due to Heartlands poor sealant idea on earlier trailers. Could you give us a rough idea of how much this cost you? I have a RV tech friend that said around $4000 to remove my large slide and replace the entire floor...

I too installed the ground control system and ran into the same problem you have. I managed to squeeze into the front generator area and barely squeezed into where the tie bar bolt is. I undid the nut and turned the bar to let the small bolt fall out. Then squeezed under the trailer and up into...

Ours are mounted inside and John was awesome on my questions when installing the Reico-Titan. System works awesome and is by far the best upgrade I have done. Maybe takes 5 minutes to set the trailer up after unhooking from the truck. I highly recommend the Reico Titan system!!

Thanks for the shout back guys. As you have probably found, there isn't a great deal of room at the door for extra shoes. I had seen a couple of other posts with modifications to the steps to create more storage. Seems like a good idea but as I said earlier, I can't find any screws or fasteners...

Has Anybody done a mod to the steps that lead upstairs for storage? I was looking this weekend for screws to take the tread off of mine but couldn't find any. Any help would be appreciated. A few members have made a storage bin under the steps but I have slightly curved/rounded steps so they...

We have our seasonal site for 4 years now. We had very good friends that were across from us for the last 3. They continually left their two dogs locked up in their trailer when they to do their stuff. These two dogs drove everybody around nuts. When they returned, our friends wouldn't believe...

Hey guys, John really helped me out when I installed the system on my Big Country. My experiance went like this. Like John, I replaced the self tapping bolts with grade 8 bolts. I twisted two of the supplied bolts off with mine off with a small 3/8 socket. Good bits are a must, and a helper...

Good job John! They look great. Hope my war dept. doesn't see them or I will have an other project......!!

Hey guys. We got out system mounted on our 3250 last weekend. Went pretty well with the only real issue was trying to get the tie bar from the original jack undone. There wasn't much room on the top of the off door side to run a wrench. I replaced the supplied fasteners with grade 8 bolts after...

A few ideas.... storage inside the steps that go upstairs, pull out bins in the pantry, more room at the dining room table, the table between the two recliners, a double fridge option, no carpet on the lower level option, king bed option, worth while storage under the bed.